ZyXEL Communications WAP3205 WDS, WEP, AES, TKIP, Network, Disable, Disable, Disabled, Encryp key, No Security, AP + Bridge, No Security, Wireless LAN, Basic Setting, Security Mode

Chapter 10 Wireless LAN

Note: You must enable the same wireless security settings on the WAP3205 v2 and on all wireless clients that you want to associate with it.

Click Network > Wireless LAN > WDS tab. The following screen opens with the Basic Setting set to Disabled, and Security Mode set to No Security.

Figure 67 Network > Wireless LAN > WDS

The following table describes the labels in this screen.

Table 42 Network > Wireless LAN > WDS

LABEL	DESCRIPTION
WDS Setup
Basic Settings	Select the operating mode for your WAP3205 v2.
	• Disable - The WAP3205 v2 works as an access point only and cannot establish
	wireless links with other APs.
	• AP + Bridge (WDS Repeater) - The WAP3205 v2 functions as a bridge and access
	point simultaneously.
	• Bridge - The WAP3205 v2 acts as a wireless network bridge and establishes wireless
	links with other APs.
	You need to know the MAC address of the peer device, which also must be in bridge
	mode. The WAP3205 v2 can establish up to five wireless links with other APs.
Local MAC	This is the MAC address of your WAP3205 v2.
Address
Phy Mode	Select the Phy mode you want the WAP3205 v2 to use. This dictates the maximum size of
	packets during data transmission.
	This field is not available when you select Disable in the Basic Setting field.
Remote MAC	This is the MAC address of the peer device that your WAP3205 v2 wants to make a bridge
Address	connection with.
	You can connect to up to 4 peer devices.
Security
EncrypType	Select whether to use WEP, TKIP or AES encryption for your WDS connection in this
	field.
	Otherwise, select No Security.
EncrypKey	The Encryp key is used to encrypt data. Peers must use the same key for data
	transmission.

	99
WAP3205 v2 User’s Guide