|
| Chapter 26 IP Source Guard |
| Table 80 ARP Inspection Status (continued) | |
| LABEL | DESCRIPTION |
| Reason | This field displays the reason the ARP packet was discarded. |
|
| MAC+VLAN: The MAC address and VLAN ID were not in the |
|
| binding table. |
|
| IP: The MAC address and VLAN ID were in the binding table, but |
|
| the IP address was not valid. |
|
| Port: The MAC address, VLAN ID, and IP address were in the |
|
| binding table, but the port number was not valid. |
|
|
|
| Delete | Select this and click Delete to remove the specified entry. |
|
|
|
| Delete | Click this to remove the selected entries. |
|
|
|
| Cancel | Click this to clear the Delete check boxes above. |
|
|
|
26.6.1 ARP Inspection VLAN Status
Use this screen to look at various statistics about ARP packets in each VLAN. To open this screen, click Advanced Application > IP Source Guard > ARP Inspection > VLAN Status.
Figure 128 ARP Inspection VLAN Status
The following table describes the labels in this screen.
Table 81 ARP Inspection VLAN Status
LABEL | DESCRIPTION |
Show VLAN range | Use this section to specify the VLANs you want to look at in the |
| section below. |
|
|
Enabled VLAN | Select this to look at all the VLANs on which ARP inspection is |
| enabled in the section below. |
|
|
Selected VLAN | Select this to look at all the VLANs in a specific range in the |
| section below. Then, enter the lowest VLAN ID (Start VID) and |
| the highest VLAN ID (End VID) you want to look at. |
|
|
Apply | Click this to display the specified range of VLANs in the section |
| below. |
|
|
| 247 |
|
|