Chapter 26 IP Source Guard
Table 85 ARP Inspection VLAN Configure (continued)
LABEL | DESCRIPTION |
Apply | Click this to display the specified range of VLANs in the section |
| below. |
|
|
VID | This field displays the VLAN ID of each VLAN in the range specified |
| above. If you configure the * VLAN, the settings are applied to all |
| VLANs. |
|
|
Enabled | Select Yes to enable ARP inspection on the VLAN. Select No to |
| disable ARP inspection on the VLAN. |
|
|
Log | Specify when the Switch generates log messages for receiving |
| ARP packets from the VLAN. |
| None: The Switch does not generate any log messages when it |
| receives an ARP packet from the VLAN. |
| Deny: The Switch generates log messages when it discards an |
| ARP packet from the VLAN. |
| Permit: The Switch generates log messages when it forwards an |
| ARP packet from the VLAN. |
| All: The Switch generates log messages every time it receives an |
| ARP packet from the VLAN. |
|
|
Apply | Click Apply to save your changes to the Switch’s |
| memory. The Switch loses these changes if it is turned off or loses |
| power, so use the Save link on the top navigation panel to save |
| your changes to the |
| configuring. |
|
|
Cancel | Click this to reset the values in this screen to their |
| values. |
|
|
254 |
| |
| ||
|
|
|