|
| Chapter 26 IP Source Guard |
| Table 84 ARP Inspection Port Configure (continued) | |
| LABEL | DESCRIPTION |
| Burst interval | The burst interval is the length of time over which the rate of ARP |
| (seconds) | packets is monitored for each port. For example, if the Rate is 15 |
|
| pps and the burst interval is 1 second, then the Switch accepts a |
|
| maximum of 15 ARP packets in every |
|
| burst interval is 5 seconds, then the Switch accepts a maximum of |
|
| 75 ARP packets in every |
|
| Enter the length |
|
|
|
| Apply | Click Apply to save your changes to the Switch’s |
|
| memory. The Switch loses these changes if it is turned off or loses |
|
| power, so use the Save link on the top navigation panel to save |
|
| your changes to the |
|
| configuring. |
|
|
|
| Cancel | Click this to reset the values in this screen to their |
|
| values. |
|
|
|
26.7.2 ARP Inspection VLAN Configure
Use this screen to enable ARP inspection on each VLAN and to specify when the Switch generates log messages for receiving ARP packets from each VLAN. To open this screen, click Advanced Application > IP Source Guard > ARP Inspection > Configure > VLAN.
Figure 132 ARP Inspection VLAN Configure
The following table describes the labels in this screen.
Table 85 ARP Inspection VLAN Configure
LABEL | DESCRIPTION |
VLAN | Use this section to specify the VLANs you want to manage in the |
| section below. |
|
|
Start VID | Enter the lowest VLAN ID you want to manage in the section |
| below. |
|
|
End VID | Enter the highest VLAN ID you want to manage in the section |
| below. |
|
|
| 253 |
|
|