Chapter 8 Basic Setting
Note: The uplink port connected to the Internet should be the root port. Otherwise, with smart isolation enabled, the isolated ports cannot access the Internet.
8.5 Switch Setup Screen
Click Basic Setting and then Switch Setup in the navigation panel to display the screen as shown. The VLAN setup screens change depending on whether you choose 802.1Q or Port Based in the VLAN Type field in this screen. Refer to the chapter on VLAN.
Figure 41 Basic Setting > Switch Setup
The following table describes the labels in this screen.
Table 11 Basic Setting > Switch Setup
LABEL | DESCRIPTION |
VLAN Type | Choose 802.1Q or Port Based. The VLAN Setup screen changes |
| depending on whether you choose 802.1Q VLAN type or Port Based |
| VLAN type in this screen. See Chapter 9 on page 95 for more |
| information. |
|
|
Bridge Control | Select Active to allow the Switch to handle bridging control protocols |
Protocol | (STP, for example). You also need to define how to treat a BPDU in the |
Transparency | Port Setup screen. |
|
|
84 |
| |
| ||
|
|
|