|
| Chapter 26 IP Source Guard |
| Table 83 ARP Inspection Configure (continued) | |
| LABEL | DESCRIPTION |
| Syslog rate | Type the maximum number of syslog messages the Switch can |
|
| send to the syslog server in one batch. This number is expressed |
|
| as a rate because the batch frequency is determined by the Log |
|
| Interval. You must configure the syslog server (Chapter 42 on |
|
| page 359) to use this. Enter 0 if you do not want the Switch to |
|
| send log messages generated by ARP packets to the syslog server. |
|
| The relationship between Syslog rate and Log interval is |
|
| illustrated in the following examples: |
|
| • 4 invalid ARP packets per second, Syslog rate is 5, Log |
|
| interval is 1: the Switch sends 4 syslog messages every |
|
| second. |
|
| • 6 invalid ARP packets per second, Syslog rate is 5, Log |
|
| interval is 2: the Switch sends 5 syslog messages every 2 |
|
| seconds. |
|
|
|
| Log interval | Type how often |
|
| syslog messages to the syslog server. Enter 0 if you want the |
|
| Switch to send syslog messages immediately. See Syslog rate |
|
| for an example of the relationship between Syslog rate and Log |
|
| interval. |
|
|
|
| Apply | Click Apply to save your changes to the Switch’s |
|
| memory. The Switch loses these changes if it is turned off or loses |
|
| power, so use the Save link on the top navigation panel to save |
|
| your changes to the |
|
| configuring. |
|
|
|
| Cancel | Click this to reset the values in this screen to their |
|
| values. |
|
|
|
26.7.1 ARP Inspection Port Configure
Use this screen to specify whether ports are trusted or untrusted ports for ARP inspection. You can also specify the maximum rate at which the Switch receives
| 251 |
|
|