Chapter 4 The Web Configurator
1Connect to the console port using a computer with terminal emulation software. See Section 3.2 on page 38 for details.
2Disconnect and reconnect the Switch’s power to begin a session. When you reconnect the Switch’s power, you will see the initial screen.
3When you see the message “Press any key to enter Debug Mode within 3 seconds ...” press any key to enter debug mode.
4Type atlc after the “Enter Debug Mode” message.
5Wait for the “Starting XMODEM upload” message before activating XMODEM upload on your terminal.
6After a configuration file upload, type atgo to restart the Switch.
Figure 19 Resetting the Switch: Via the Console Port
ZyNOS Version: V3.90(BBC.0)b1 04/28/2009 09:20:42
Bootbase Version: V1.00 10/22/2007 12:48:50
RAM:Size = 128 Mbytes
DRAM POST: Testing:131072K OK
DRAM Test SUCCESS !
FLASH: Intel 64M
ZyNOS Version: V3.90(BBC.0)b1 04/28/2009 09:20:42
Press any key to enter debug mode within 3 seconds.
.....................................
Enter Debug Mode ras> atlc
Starting XMODEM upload (CRC mode)....
CCCCCCCCCCCCCCCC
Total 393216 bytes received. Erasing..
................................................................
OK
ras> atgo
The Switch is now reinitialized with a default configuration file including the default password of “1234”.
| 53 |
|
|