Husqvarna 1030 BioClip, 1200 manual Presentation, Location of the controls

Page 11

PRESENTATION

Presentation

These instructions describe two machine models, Rider 1030 Bioclip and Rider 1200.

Rider 1030 Bioclip and Rider 1200 are fitted with Vanguard V-Twin engines from Briggs & Stratton of 18 h.p.

The cutting unit on Rider 1200 has rear ejection with a moving width of 1200 mm.

The power transmission from the engine is handled by a hydrostatic gearbox which enables stepless variation of the speed with the foot pedals.

There is one pedal for driving forward and one for reversing.

Rider 1030 has a cutting unit with Bioclip function and a mowing width of 1030 mm.

8	7		6	5	4	3	2	1	13
	9	10	11					12	13	14

Location of the controls

1.	Ignition lock	8.	Speed limiter for driving forward
2.	Choke lever	9.	Brake pedal
3.	Throttle control	10.	Lock button for parking brake
4.	Counter	11.	Lever for adjustment of seat
5.	Lever for adjustment of cutting height	12.	Fuel tank cap
6.	Lifting lever for cutting unit with lock button	13.	Main lock
7.	Speed limiter for reversing	14.	Lever to disengage the drive

English – 9

Image 11

Contents 101 89 Rider 1030 BioClip RiderSvenska Contents II. Slope operation Safety InstructionsSafe operation practices for ride-on mowers General operationIV. Service Read the instructions Explanation of SymbolsGeneral use These instructions are for your safety. Read them carefullyDo as follows Driving on slopesDo not do the following MaintenanceChildren Never drive the machine in an enclosed space Location of the controls PresentationPresentation Speed limiter Throttle controlChoke lever Lift lever for cutting unit Cutting unitFuelling Lever for adjustment of the cutting heightParking brake SeatStarting the engine DrivingBefore starting Driving the machine Cutting tips Disengage lever Stopping the engineMAX Hours MaintenanceMaintenance schedule Daily Maintenance intervalRight-hand fender Dismantling of the machine hoodsEngine hood Front hoodChecking of the fuel pump’s air filter Check the engine’s oil levelCheck the engine’s cooling air intake Check the transmission’s oil level Check the transmission’s air intakeChecking and adjustment of the steering wires Poorly adjusted brakes can result in reduced braking power Checking and adjusting the brakeCheck the level of the battery acid Check the safety systemReplacing the air filter Do not use compressed air to clean the paper filterMaintenance Checking and adjusting the cutting unit’s parallelism Checking the blades Dismantling the cutting unitChanging the oil General lubrication Replacement of the oil filterLubrication Checking and adjustment of the throttle wire Checking the tyre pressure Replacement of the fuel filterProblem Procedure Trouble Shooting ScheduleWinter storage ServiceStorage Wiring Diagram Rider 1030 Bioclip, Rider Technical DataEnglish «*2h6+¬ English «*2h6+¬