Husqvarna 1200 manual Checking and adjusting the brake, Check the level of the battery acid

Page 24

MAINTENANCE

Checking and adjusting the brake

Check that the brake is correctly adjusted by placing the machine on a slight downward slope and applying the brake.

If the machine does not stand still the brake should be adjusted.

The brake is adjusted as follows:

1.Release the lock nuts (A).

2.Tension the wire with the adjusting screw (B) until the play in the wire is taken up.

3.Tighten the lock nuts (A).

4.On completion of the adjustment the brake should be checked again.

!WARNING!

Poorly adjusted brakes can result in reduced braking power.

Check the level of the battery acid

Check that the level of the battery acid lies be- tween the markings. Top up the cells with distilled water only.

!WARNING!

Procedures on contact with acid

External: Rinse well with plenty of water.

Internal: Drink large quantities of water or milk. Contact a doctor as soon as possible.

Eyes: Rinse well with plenty of water. Contact a doctor as soon as pos- sible.

Batteries emit explosive gas. Sparks, flames and cigarettes must absolutely not be brought into the vicinity of the battery.

B	A
	A

Check the safety system

The machine is equipped with a safety system which prevents starting or driving the machine unless someone is sitting in the seat. Check daily that the safety system functions.

22 – English

Image 24

Contents Rider 1030 BioClip Rider 101 89Svenska Contents Safety Instructions Safe operation practices for ride-on mowersGeneral operation II. Slope operationIV. Service Explanation of Symbols Read the instructionsThese instructions are for your safety. Read them carefully General useDriving on slopes Do as followsMaintenance ChildrenDo not do the following Never drive the machine in an enclosed space Presentation PresentationLocation of the controls Throttle control Choke leverSpeed limiter Cutting unit Lift lever for cutting unitLever for adjustment of the cutting height Parking brakeSeat FuellingDriving Before startingStarting the engine Driving the machine Cutting tips Stopping the engine MAXDisengage lever Maintenance Maintenance scheduleDaily Maintenance interval HoursDismantling of the machine hoods Engine hoodFront hood Right-hand fenderCheck the engine’s oil level Check the engine’s cooling air intakeChecking of the fuel pump’s air filter Check the transmission’s air intake Check the transmission’s oil levelChecking and adjustment of the steering wires Checking and adjusting the brake Check the level of the battery acidCheck the safety system Poorly adjusted brakes can result in reduced braking powerDo not use compressed air to clean the paper filter Replacing the air filterMaintenance Checking and adjusting the cutting unit’s parallelism Dismantling the cutting unit Checking the bladesChanging the oil Replacement of the oil filter LubricationGeneral lubrication Checking and adjustment of the throttle wire Replacement of the fuel filter Checking the tyre pressureTrouble Shooting Schedule Problem ProcedureService StorageWinter storage Wiring Diagram Technical Data Rider 1030 Bioclip, RiderEnglish «*2h6+¬ English «*2h6+¬