Husqvarna 1200 manual Lever for adjustment of the cutting height, Parking brake, Seat, Fuelling

Page 14

PRESENTATION

Lever for adjustment of the cutting height

The cutting height can be adjusted to 7 different positions with the cutting height lever.

To achieve an even cutting height it is important that the tyre pressures are the same on the front wheels (60 kPa).

Parking brake

The parking brake is applied as follows:

1. Push down the brake pedal.

2. Push in the lock button on the steering column.

3. Release the brake pedal while holding the button pressed.

The parking brake lock disengages automatically when the brake pedal is pressed.

Seat

The seat has a jointed attachment on the front edge and can be tipped forward.

The seat can also be adjusted lengthways.

To adjust move the lever under the front edge of the seat to the left, so that the seat can be moved forward or backwards to the required position.

Fuelling

The engine should be run on at least 92 octane leaded or unleaded petrol (not oil mixed). For USA and Canada at least 87 octane leaded or unleaded petrol (not oil mixed).

!WARNING!

Petrol is highly inflammable. Observe care and fuel outdoors (see safety instructions).

12 – English

Image 14

Contents Rider 1030 BioClip Rider 101 89Svenska Contents General operation Safety InstructionsSafe operation practices for ride-on mowers II. Slope operationIV. Service Explanation of Symbols Read the instructionsThese instructions are for your safety. Read them carefully General useDriving on slopes Do as followsDo not do the following MaintenanceChildren Never drive the machine in an enclosed space Location of the controls PresentationPresentation Speed limiter Throttle controlChoke lever Cutting unit Lift lever for cutting unitSeat Lever for adjustment of the cutting heightParking brake FuellingStarting the engine DrivingBefore starting Driving the machine Cutting tips Disengage lever Stopping the engineMAX Daily Maintenance interval MaintenanceMaintenance schedule HoursFront hood Dismantling of the machine hoodsEngine hood Right-hand fenderChecking of the fuel pump’s air filter Check the engine’s oil levelCheck the engine’s cooling air intake Check the transmission’s air intake Check the transmission’s oil levelChecking and adjustment of the steering wires Check the safety system Checking and adjusting the brakeCheck the level of the battery acid Poorly adjusted brakes can result in reduced braking powerDo not use compressed air to clean the paper filter Replacing the air filterMaintenance Checking and adjusting the cutting unit’s parallelism Dismantling the cutting unit Checking the bladesChanging the oil General lubrication Replacement of the oil filterLubrication Checking and adjustment of the throttle wire Replacement of the fuel filter Checking the tyre pressureTrouble Shooting Schedule Problem ProcedureWinter storage ServiceStorage Wiring Diagram Technical Data Rider 1030 Bioclip, RiderEnglish «*2h6+¬ English «*2h6+¬