Husqvarna 1030 BioClip, 1200 manual Replacing the air filter

Page 25

MAINTENANCE

Replacing the air filter

If the engine seems to lack power or does not run smoothly this may be because the air filter is clogged.

It is therefore important to replace the air filter at regular intervals (see maintenance schedule on page 17 for correct service interval).

The air filter is replaced as follows:

1. Dismantle the engine hood as described on page 18.

2.Fold out the two snap-locks and lift off the cover on the air filter housing.

3.Release and remove the wing-nut in the centre of the air filter and lift off the paper filter with pre- filter.

4.Pull off the foam plastic pre-filter from the paper filter and wash clean in mild detergent.

Squeeze it dry in a clean cloth.

Drench it with new engine oil. Wrap the filter in an absorbent cloth and squeeze out excess oil.

If the paper filter is heavily soiled it should be replaced.

IMPORTANT INFORMATION

Do not use compressed air to clean the paper filter.

5.Fit the air filter as follows:

Push the pre-filter over the paper filter.

Fit the paper filter with pre-filter in the air filter housing and tighten the wing-nut in the centre.

Replace the cover over the air filter housing and clamp the two snap-locks tight.

English – 23

Image 25

Contents 101 89 Rider 1030 BioClip RiderSvenska Contents Safe operation practices for ride-on mowers Safety InstructionsGeneral operation II. Slope operationIV. Service Read the instructions Explanation of SymbolsGeneral use These instructions are for your safety. Read them carefullyDo as follows Driving on slopesChildren MaintenanceDo not do the following Never drive the machine in an enclosed space Presentation PresentationLocation of the controls Choke lever Throttle controlSpeed limiter Lift lever for cutting unit Cutting unitParking brake Lever for adjustment of the cutting heightSeat FuellingBefore starting DrivingStarting the engine Driving the machine Cutting tips MAX Stopping the engineDisengage lever Maintenance schedule MaintenanceDaily Maintenance interval HoursEngine hood Dismantling of the machine hoodsFront hood Right-hand fenderCheck the engine’s cooling air intake Check the engine’s oil levelChecking of the fuel pump’s air filter Check the transmission’s oil level Check the transmission’s air intakeChecking and adjustment of the steering wires Check the level of the battery acid Checking and adjusting the brakeCheck the safety system Poorly adjusted brakes can result in reduced braking powerReplacing the air filter Do not use compressed air to clean the paper filterMaintenance Checking and adjusting the cutting unit’s parallelism Checking the blades Dismantling the cutting unitChanging the oil Lubrication Replacement of the oil filterGeneral lubrication Checking and adjustment of the throttle wire Checking the tyre pressure Replacement of the fuel filterProblem Procedure Trouble Shooting ScheduleStorage ServiceWinter storage Wiring Diagram Rider 1030 Bioclip, Rider Technical DataEnglish «*2h6+¬ English «*2h6+¬