Husqvarna 1200, 1030 BioClip manual Checking the tyre pressure, Replacement of the fuel filter

Page 32

MAINTENANCE

Checking the tyre pressure

The tyre pressure should be 60 kPa (0.6 kp/cm2) all round.

To improve driving the pressure on the rear tyres can be reduced to 40 kPa (0.4 kp/cm2).

The maximum tyre pressure is 100 kPa (1.0 kp/cm2).

IMPORTANT INFORMATION

Different tyre pressures on the front tyres will result in the blades cutting the grass at different heights.

Replacement of the fuel filter

Replace the fuel filter every 100 running hours (once per season) or more frequently if it is clogged.

Replace the filter as follows:

1.Dismantle the engine hood as described on page 18.

2. Move the hose clips away from the filter. Use a pair of flat pliers.

3. Pull off the filter from the hose ends.

4.Press in the new filter on the hose ends. If necessary soap solution can be applied on the filter ends to simplify fitting.

5.Push the hose clips back on the filter and tighten.

30 – English

Image 32
Contents Rider 1030 BioClip Rider 101 89Svenska Contents Safety Instructions Safe operation practices for ride-on mowersGeneral operation II. Slope operationIV. Service Explanation of Symbols Read the instructionsThese instructions are for your safety. Read them carefully General useDriving on slopes Do as followsDo not do the following MaintenanceChildren Never drive the machine in an enclosed space Location of the controls PresentationPresentation Speed limiter Throttle controlChoke lever Cutting unit Lift lever for cutting unitLever for adjustment of the cutting height Parking brakeSeat FuellingStarting the engine DrivingBefore starting Driving the machine Cutting tips Disengage lever Stopping the engineMAX Maintenance Maintenance scheduleDaily Maintenance interval HoursDismantling of the machine hoods Engine hoodFront hood Right-hand fenderChecking of the fuel pump’s air filter Check the engine’s oil levelCheck the engine’s cooling air intake Check the transmission’s air intake Check the transmission’s oil levelChecking and adjustment of the steering wires Checking and adjusting the brake Check the level of the battery acidCheck the safety system Poorly adjusted brakes can result in reduced braking powerDo not use compressed air to clean the paper filter Replacing the air filterMaintenance Checking and adjusting the cutting unit’s parallelism Dismantling the cutting unit Checking the bladesChanging the oil General lubrication Replacement of the oil filterLubrication Checking and adjustment of the throttle wire Replacement of the fuel filter Checking the tyre pressureTrouble Shooting Schedule Problem ProcedureWinter storage ServiceStorage Wiring Diagram Technical Data Rider 1030 Bioclip, RiderEnglish «*2h6+¬ English «*2h6+¬