Husqvarna 1030 BioClip, 1200 manual Changing the oil

Page 29

MAINTENANCE

Changing the oil

The oil should be changed for the first time after 8 hours of running time. Thereafter it should be changed every 50 hours of running time. If the engine is run hard or during high temperatures the oil should be changed every 25 running hours.

!WARNING!

Engine oil can be very hot if it is drained off directly after the engine is stopped. Therefore allow the engine to cool down first.

Change the oil as follows:

1.Dismantle the engine hood as described on page 18.

2.Place a receptacle under the engine’s drain plug.

3.Remove the dip stick. Remove the drain plug on the left-hand side of the engine.

4.Let the oil run out into the receptacle.

5.Fit the oil plug and tighten well.

6.Fill up with oil to the FULL mark on the dip stick. Use engine oil SAE 30 or SAE 10W-30, class CD–CF (over 0°). Use engine oil SAE 5W-30, class CD–CF (below 0°).

The total oil volume in the engine is 1.3 litres.

7.Run the engine warm and then check that there is no leakage from the oil plug.

The oil is filled in the same hole as the dip stick.

IMPORTANT INFORMATION

Used engine oil is hazardous to health and must by law not be poured out on the ground or in the nature, but shall be handed in to a workshop or special environmental station. Avoid skin contact, wash with soap and water in the event of spillage.

	ADD	FULL
ADD	FULL

English – 27

Image 29

Contents 101 89 Rider 1030 BioClip RiderSvenska Contents Safe operation practices for ride-on mowers Safety InstructionsGeneral operation II. Slope operationIV. Service Read the instructions Explanation of SymbolsGeneral use These instructions are for your safety. Read them carefullyDo as follows Driving on slopesDo not do the following MaintenanceChildren Never drive the machine in an enclosed space Location of the controls PresentationPresentation Speed limiter Throttle controlChoke lever Lift lever for cutting unit Cutting unitParking brake Lever for adjustment of the cutting heightSeat FuellingStarting the engine DrivingBefore starting Driving the machine Cutting tips Disengage lever Stopping the engineMAX Maintenance schedule MaintenanceDaily Maintenance interval HoursEngine hood Dismantling of the machine hoodsFront hood Right-hand fenderChecking of the fuel pump’s air filter Check the engine’s oil levelCheck the engine’s cooling air intake Check the transmission’s oil level Check the transmission’s air intakeChecking and adjustment of the steering wires Check the level of the battery acid Checking and adjusting the brakeCheck the safety system Poorly adjusted brakes can result in reduced braking powerReplacing the air filter Do not use compressed air to clean the paper filterMaintenance Checking and adjusting the cutting unit’s parallelism Checking the blades Dismantling the cutting unitChanging the oil General lubrication Replacement of the oil filterLubrication Checking and adjustment of the throttle wire Checking the tyre pressure Replacement of the fuel filterProblem Procedure Trouble Shooting ScheduleWinter storage ServiceStorage Wiring Diagram Rider 1030 Bioclip, Rider Technical DataEnglish «*2h6+¬ English «*2h6+¬