Husqvarna 1200 manual Dismantling of the machine hoods, Engine hood, Front hood, Right-hand fender

Page 20

MAINTENANCE

Dismantling of the machine hoods

Engine hood

Release the two rubber straps on the rear edge of the engine hood and lift off the hood.

Front hood

Dismantle the screws (1, 2 and 3) and lift off the front hood.

Right-hand fender

Dismantle the foot-plate (1), screws (2 and 3), and lift off the fender.

3

2

1

2

1

3

Left-hand fender

Dismantle the screws (1 and 2), and lift off the fender.

1

2

18 – English

Image 20

Contents Rider 1030 BioClip Rider 101 89Svenska Contents Safety Instructions Safe operation practices for ride-on mowersGeneral operation II. Slope operationIV. Service Explanation of Symbols Read the instructionsThese instructions are for your safety. Read them carefully General useDriving on slopes Do as followsDo not do the following MaintenanceChildren Never drive the machine in an enclosed space Location of the controls PresentationPresentation Speed limiter Throttle controlChoke lever Cutting unit Lift lever for cutting unitLever for adjustment of the cutting height Parking brakeSeat FuellingStarting the engine DrivingBefore starting Driving the machine Cutting tips Disengage lever Stopping the engineMAX Maintenance Maintenance scheduleDaily Maintenance interval HoursDismantling of the machine hoods Engine hoodFront hood Right-hand fenderChecking of the fuel pump’s air filter Check the engine’s oil levelCheck the engine’s cooling air intake Check the transmission’s air intake Check the transmission’s oil levelChecking and adjustment of the steering wires Checking and adjusting the brake Check the level of the battery acidCheck the safety system Poorly adjusted brakes can result in reduced braking powerDo not use compressed air to clean the paper filter Replacing the air filterMaintenance Checking and adjusting the cutting unit’s parallelism Dismantling the cutting unit Checking the bladesChanging the oil General lubrication Replacement of the oil filterLubrication Checking and adjustment of the throttle wire Replacement of the fuel filter Checking the tyre pressureTrouble Shooting Schedule Problem ProcedureWinter storage ServiceStorage Wiring Diagram Technical Data Rider 1030 Bioclip, RiderEnglish «*2h6+¬ English «*2h6+¬