Husqvarna 1200, 1030 BioClip manual Replacement of the oil filter, Lubrication, General lubrication

Page 30

MAINTENANCE

Replacement of the oil filter

1. Dismantle the engine hood as described on page 18.

2.Drain off the engine oil according to the work description “Changing of engine oil” on page 27.

3. Dismantle the oil filter. If necessary use a filter extractor.

4.Apply new, clean engine oil on the seal for the new filter.

5. Fit the filter and tighten by hand.

6. Run the engine warm and check that there is no leakage round the oil filter seal.

Lubrication

The following three lubrication points shall be lubricated regularly with graphite grease of good quality.

In the event of daily use lubrication should be conducted twice a week.

General lubrication

All joints and bearings are lubricated on manufacture with molybdenum sulphide grease.

Re-grease with same type of grease.

Lubricate the steering and control wires with engine oil.

Conduct this lubrication regularly: during daily use of the machine it should be lubricated twice a week.

28 – English

Image 30

Contents Rider 1030 BioClip Rider 101 89Svenska Contents General operation Safety InstructionsSafe operation practices for ride-on mowers II. Slope operationIV. Service Explanation of Symbols Read the instructionsThese instructions are for your safety. Read them carefully General useDriving on slopes Do as followsMaintenance ChildrenDo not do the following Never drive the machine in an enclosed space Presentation PresentationLocation of the controls Throttle control Choke leverSpeed limiter Cutting unit Lift lever for cutting unitSeat Lever for adjustment of the cutting heightParking brake FuellingDriving Before startingStarting the engine Driving the machine Cutting tips Stopping the engine MAXDisengage lever Daily Maintenance interval MaintenanceMaintenance schedule HoursFront hood Dismantling of the machine hoodsEngine hood Right-hand fenderCheck the engine’s oil level Check the engine’s cooling air intakeChecking of the fuel pump’s air filter Check the transmission’s air intake Check the transmission’s oil levelChecking and adjustment of the steering wires Check the safety system Checking and adjusting the brakeCheck the level of the battery acid Poorly adjusted brakes can result in reduced braking powerDo not use compressed air to clean the paper filter Replacing the air filterMaintenance Checking and adjusting the cutting unit’s parallelism Dismantling the cutting unit Checking the bladesChanging the oil Replacement of the oil filter LubricationGeneral lubrication Checking and adjustment of the throttle wire Replacement of the fuel filter Checking the tyre pressureTrouble Shooting Schedule Problem ProcedureService StorageWinter storage Wiring Diagram Technical Data Rider 1030 Bioclip, RiderEnglish «*2h6+¬ English «*2h6+¬