Husqvarna 1030 BioClip, 1200 manual Driving, Before starting, Starting the engine

Page 15

DRIVING

Before starting

•Read the safety instructions and information on the location and function of the controls before starting (see pages 5–12).

•Conduct daily maintenance before starting (see maintenance schedule on page 17).

•Adjust the seat to the required position.

Starting the engine

1.Lift up the cutting unit by pulling the lever back- wards to locked position (transport position) and apply the parking brake.

2. Move the throttle control to the middle position.

3.If the engine is cold move the choke lever backwards to its end position.

4. Turn the ignition key to the start position.

English – 13

Image 15

Contents 101 89 Rider 1030 BioClip RiderSvenska Contents II. Slope operation Safety InstructionsSafe operation practices for ride-on mowers General operationIV. Service Read the instructions Explanation of SymbolsGeneral use These instructions are for your safety. Read them carefullyDo as follows Driving on slopesMaintenance ChildrenDo not do the following Never drive the machine in an enclosed space Presentation PresentationLocation of the controls Throttle control Choke leverSpeed limiter Lift lever for cutting unit Cutting unitFuelling Lever for adjustment of the cutting heightParking brake SeatDriving Before startingStarting the engine Driving the machine Cutting tips Stopping the engine MAXDisengage lever Hours MaintenanceMaintenance schedule Daily Maintenance intervalRight-hand fender Dismantling of the machine hoodsEngine hood Front hoodCheck the engine’s oil level Check the engine’s cooling air intakeChecking of the fuel pump’s air filter Check the transmission’s oil level Check the transmission’s air intakeChecking and adjustment of the steering wires Poorly adjusted brakes can result in reduced braking power Checking and adjusting the brakeCheck the level of the battery acid Check the safety systemReplacing the air filter Do not use compressed air to clean the paper filterMaintenance Checking and adjusting the cutting unit’s parallelism Checking the blades Dismantling the cutting unitChanging the oil Replacement of the oil filter LubricationGeneral lubrication Checking and adjustment of the throttle wire Checking the tyre pressure Replacement of the fuel filterProblem Procedure Trouble Shooting ScheduleService StorageWinter storage Wiring Diagram Rider 1030 Bioclip, Rider Technical DataEnglish «*2h6+¬ English «*2h6+¬