Husqvarna 1030 BioClip, 1200 Check the engine’s oil level, Check the engine’s cooling air intake

Page 21

MAINTENANCE

Check the engine’s oil level

Check the oil level in the engine when the machine is horizontal.

Dismantle the engine hood as per the description on page 18.

Take out the dip stick, wipe off the oil, and insert again.

The dip stick must be fully screwed down.

Now take out the dip stick again and check the oil level.

The oil level should lie between the markings on dip stick. If the level approaches the ADD mark, top up with oil to the FULL mark on the dip stick.

The oil is filled in the same hole as the dip stick is in.

Use engine oil SAE 30 or SAE 10W-30, class CD– CF (over 0°). Use engine oil SAE 5W-30, class CD–CF (below 0°).

The total oil volume in the engine is 1.3 litres.

	ADD	FULL
ADD	FULL

Check the engine’s cooling air intake

Dismantle the engine hood as described on page 18.

Check that the cooling intake is free from leaves, grass and dirt.

If the cooling intake is blocked this will interfere with the cooling of the engine, which can damage the engine.

Checking of the fuel pump’s air filter

Check regularly that the fuel pump’s air filter is free from dirt.

The filter can when necessary be cleaned with a brush.

English – 19

Image 21

Contents 101 89 Rider 1030 BioClip RiderSvenska Contents Safe operation practices for ride-on mowers Safety InstructionsGeneral operation II. Slope operationIV. Service Read the instructions Explanation of SymbolsGeneral use These instructions are for your safety. Read them carefullyDo as follows Driving on slopesMaintenance ChildrenDo not do the following Never drive the machine in an enclosed space Presentation PresentationLocation of the controls Throttle control Choke leverSpeed limiter Lift lever for cutting unit Cutting unitParking brake Lever for adjustment of the cutting heightSeat FuellingDriving Before startingStarting the engine Driving the machine Cutting tips Stopping the engine MAXDisengage lever Maintenance schedule MaintenanceDaily Maintenance interval HoursEngine hood Dismantling of the machine hoodsFront hood Right-hand fenderCheck the engine’s oil level Check the engine’s cooling air intakeChecking of the fuel pump’s air filter Check the transmission’s oil level Check the transmission’s air intakeChecking and adjustment of the steering wires Check the level of the battery acid Checking and adjusting the brakeCheck the safety system Poorly adjusted brakes can result in reduced braking powerReplacing the air filter Do not use compressed air to clean the paper filterMaintenance Checking and adjusting the cutting unit’s parallelism Checking the blades Dismantling the cutting unitChanging the oil Replacement of the oil filter LubricationGeneral lubrication Checking and adjustment of the throttle wire Checking the tyre pressure Replacement of the fuel filterProblem Procedure Trouble Shooting ScheduleService StorageWinter storage Wiring Diagram Rider 1030 Bioclip, Rider Technical DataEnglish «*2h6+¬ English «*2h6+¬