Husqvarna 1200, 1030 BioClip manual Explanation of Symbols, Read the instructions

Page 6

EXPLANATION OF SYMBOLS

These symbols are on the machine and in the instructions.

Study them carefully so that you know what they mean.

Read the instructions.

R N

Reverse

Neutral

Fast

Slow

Engine off

Battery

Choke

Fuel

Oil pressure

Cutting height

Backwards

Forwards

Ignition

Hydrostatic freewheel

!

Use hearing protection

Clutch in

Clutch out

Parking brake

Brake

Warning

	Sound level Warning! Rotating blades	Warning! Risk that the machine can tip over	Never drive across a slope	European standard for
				machine safety

Never use the machine if persons, especially children, or animals, are in the vicinity

Never carry passengers on the

machine or equipment

Starting instructions Read the instructions Check the engine’s oil level Check the hydrostat’s oil level Lift up the cutting unit

Put the gear shift/hydrostat pedal in neutral

Brake

If the engine is cold use the choke Start the engine

Release the parking brake before driving

Keep hands and feet away	Drive very slowly
from under the hood when	without the cutting unit
the engine is running

Speed limiter pedal forwards

Neutral

Speed limiter pedal reverse

Switch off the engine and take off the ignition cable before repairs or maintenance

4 – English

Image 6

Contents Rider 1030 BioClip Rider 101 89Svenska Contents General operation Safety InstructionsSafe operation practices for ride-on mowers II. Slope operationIV. Service Explanation of Symbols Read the instructionsThese instructions are for your safety. Read them carefully General useDriving on slopes Do as followsMaintenance ChildrenDo not do the following Never drive the machine in an enclosed space Presentation PresentationLocation of the controls Throttle control Choke leverSpeed limiter Cutting unit Lift lever for cutting unitSeat Lever for adjustment of the cutting heightParking brake FuellingDriving Before startingStarting the engine Driving the machine Cutting tips Stopping the engine MAXDisengage lever Daily Maintenance interval MaintenanceMaintenance schedule HoursFront hood Dismantling of the machine hoodsEngine hood Right-hand fenderCheck the engine’s oil level Check the engine’s cooling air intakeChecking of the fuel pump’s air filter Check the transmission’s air intake Check the transmission’s oil levelChecking and adjustment of the steering wires Check the safety system Checking and adjusting the brakeCheck the level of the battery acid Poorly adjusted brakes can result in reduced braking powerDo not use compressed air to clean the paper filter Replacing the air filterMaintenance Checking and adjusting the cutting unit’s parallelism Dismantling the cutting unit Checking the bladesChanging the oil Replacement of the oil filter LubricationGeneral lubrication Checking and adjustment of the throttle wire Replacement of the fuel filter Checking the tyre pressureTrouble Shooting Schedule Problem ProcedureService StorageWinter storage Wiring Diagram Technical Data Rider 1030 Bioclip, RiderEnglish «*2h6+¬ English «*2h6+¬