Husqvarna 1030 BioClip, 1200 manual Trouble Shooting Schedule, Problem Procedure

Page 33

TROUBLE SHOOTING SCHEDULE

Problem	Procedure

Engine will not start.	•	Fuel tank empty.
	•	Plugs defective.
	•	Plug connections defective.
	• Dirt in carburettor or fuel pipe.

Starter does not pull round engine.	•	Battery flat.
	• Bad contact between cables and battery terminals.
	• Lift lever for cutting unit in wrong position.
	• Main fuse blown. The fuse is located in front of the
		battery under the battery cover.
	•	Ignition lock faulty.
	• Gear shift/hydrostat pedal not in neutral.

Engine does not run smoothly.

•Plugs defective.

•Carburettor incorrectly set.

•Air filter clogged.

•Fuel tank vent blocked.

•Ignition setting defective.

•Dirt in fuel pipe.

Engine seems to have no power.	•	Air filter clogged.
	•	Plug defective.
	• Dirt in carburettor or fuel pipe.
	•	Carburettor incorrectly set.

Engine overheats.	•	Engine overloaded.
	• Air intake or cooling flanges blocked.
	•	Fan damaged.
	• Too little or no oil in engine.
	•	Ignition defective.
	•	Plugs defective.

Battery does not charge.	•	One or more cells in the battery faulty.
	• Bad contact between battery terminals and cables.

Machine vibrates.	•	Blades are loose.
	•	Engine is loose.
	• Imbalance on one or more blades, resulting from
		damage or inferior balancing after sharpening.

Uneven mowing.	•	Blades blunt.
	• Cutting unit set skew.
	• Long or wet grass.
	• Grass blockage under hood.
	• Different tyre pressures on right and left sides.
	•	Over-speeding
	•	Drive belts slipping.

English – 31

Image 33

Contents 101 89 Rider 1030 BioClip RiderSvenska Contents Safe operation practices for ride-on mowers Safety InstructionsGeneral operation II. Slope operationIV. Service Read the instructions Explanation of SymbolsGeneral use These instructions are for your safety. Read them carefullyDo as follows Driving on slopesMaintenance ChildrenDo not do the following Never drive the machine in an enclosed space Presentation PresentationLocation of the controls Throttle control Choke leverSpeed limiter Lift lever for cutting unit Cutting unitParking brake Lever for adjustment of the cutting heightSeat FuellingDriving Before startingStarting the engine Driving the machine Cutting tips Stopping the engine MAXDisengage lever Maintenance schedule MaintenanceDaily Maintenance interval HoursEngine hood Dismantling of the machine hoodsFront hood Right-hand fenderCheck the engine’s oil level Check the engine’s cooling air intakeChecking of the fuel pump’s air filter Check the transmission’s oil level Check the transmission’s air intakeChecking and adjustment of the steering wires Check the level of the battery acid Checking and adjusting the brakeCheck the safety system Poorly adjusted brakes can result in reduced braking powerReplacing the air filter Do not use compressed air to clean the paper filterMaintenance Checking and adjusting the cutting unit’s parallelism Checking the blades Dismantling the cutting unitChanging the oil Replacement of the oil filter LubricationGeneral lubrication Checking and adjustment of the throttle wire Checking the tyre pressure Replacement of the fuel filterProblem Procedure Trouble Shooting ScheduleService StorageWinter storage Wiring Diagram Rider 1030 Bioclip, Rider Technical DataEnglish «*2h6+¬ English «*2h6+¬