Husqvarna 1200, 1030 BioClip manual Driving on slopes, Do as follows

Page 8

SAFETY INSTRUCTIONS

Watch out for traffic when working close to a road, or crossing one.

Be careful when rounding a fixed object so that the blades do not hit it. Never drive intentionally over a foreign object.

The machine is heavy and can cause very severe crush injuries. Be extra careful when loading it on a trailer or truck.

Be careful when pulling a load or using heavy equipment.

a.Only use approved tow hooks.

b.Limit the load to what you can manage safely.

c.Do not make sharp turns. Be careful when reversing.

d.Use counterweights or wheel weights when indicated in the instructions.

Driving on slopes

Driving on slopes is one of the situations where there is the most serious risk that the driver can loose control or that the machine tips over, which can cause severe injuries or be fatal. All slopes require extra care. If you cannot reverse up the slope or if you feel uncertain avoid cutting it.

Do as follows:

Remove obstacles such as stones and branches etc.

Cut upwards and downwards, not sideways.

Look out for and avoid driving over furrows, holes or mounds. On uneven surfaces it is easier for the machine to tip over. High grass can conceal obstacles.

Drive slowly. Select a low gear to avoid having to stop and changing gear. It is also easier to use the gear to brake in a low gear.

Follow the manufacturer’s recommendations on wheel weights or counterweights to increase stability.

Be extra careful with the grass collector or other equipment which can alter the stability of the machine.

Always drive smoothly and slowly on slopes. Avoid sudden changes of speed or direction.

Avoid starting or stopping on a slope. If the tyres begin to skid switch off the blades and drive slowly down the slope.

 

 

85

0

 

R

 

RIDE

 

 

 

 

 

850

 

 

 

RIDER

 

 

 

Be extra careful when driving on slopes.

Cut slopes upwards and downwards, not sideways.

6 – English

Image 8
Contents Rider 1030 BioClip Rider 101 89Svenska Contents Safety Instructions Safe operation practices for ride-on mowersGeneral operation II. Slope operationIV. Service Explanation of Symbols Read the instructionsThese instructions are for your safety. Read them carefully General useDriving on slopes Do as followsDo not do the following MaintenanceChildren Never drive the machine in an enclosed space Location of the controls PresentationPresentation Speed limiter Throttle controlChoke lever Cutting unit Lift lever for cutting unitLever for adjustment of the cutting height Parking brakeSeat FuellingStarting the engine DrivingBefore starting Driving the machine Cutting tips Disengage lever Stopping the engineMAX Maintenance Maintenance scheduleDaily Maintenance interval HoursDismantling of the machine hoods Engine hoodFront hood Right-hand fenderChecking of the fuel pump’s air filter Check the engine’s oil levelCheck the engine’s cooling air intake Check the transmission’s air intake Check the transmission’s oil levelChecking and adjustment of the steering wires Checking and adjusting the brake Check the level of the battery acidCheck the safety system Poorly adjusted brakes can result in reduced braking powerDo not use compressed air to clean the paper filter Replacing the air filterMaintenance Checking and adjusting the cutting unit’s parallelism Dismantling the cutting unit Checking the bladesChanging the oil General lubrication Replacement of the oil filterLubrication Checking and adjustment of the throttle wire Replacement of the fuel filter Checking the tyre pressureTrouble Shooting Schedule Problem ProcedureWinter storage ServiceStorage Wiring Diagram Technical Data Rider 1030 Bioclip, RiderEnglish «*2h6+¬ English «*2h6+¬