Husqvarna 1200, 1030 BioClip manual Driving the machine

Page 16

DRIVING

5.When the engine starts release the ignition key immediately back to neutral position.

IMPORTANT INFORMATION

Do not run the starter for more than about 5 seconds at a time. If the engine does not start, wait about 10 seconds before trying again.

6.Push the choke lever gradually forward when the engine has started.

7. Set the required engine speed with the throttle control.

!WARNING!

Never run the engine indoors, in en- closed or poorly ventilated areas. The exhaust fumes contain toxic carbon monoxide.

Driving the machine

1. Release the parking brake by pressing the brake pedal.

2.Carefully press down one of the pedals until the required speed is obtained.

To drive forward press down pedal (1), or to reverse pedal (2).

1

2

14 – English

Image 16

Contents Rider 1030 BioClip Rider 101 89Svenska Contents Safety Instructions Safe operation practices for ride-on mowersGeneral operation II. Slope operationIV. Service Explanation of Symbols Read the instructionsThese instructions are for your safety. Read them carefully General useDriving on slopes Do as followsChildren MaintenanceDo not do the following Never drive the machine in an enclosed space Presentation PresentationLocation of the controls Choke lever Throttle controlSpeed limiter Cutting unit Lift lever for cutting unitLever for adjustment of the cutting height Parking brakeSeat FuellingBefore starting DrivingStarting the engine Driving the machine Cutting tips MAX Stopping the engineDisengage lever Maintenance Maintenance scheduleDaily Maintenance interval HoursDismantling of the machine hoods Engine hoodFront hood Right-hand fenderCheck the engine’s cooling air intake Check the engine’s oil levelChecking of the fuel pump’s air filter Check the transmission’s air intake Check the transmission’s oil levelChecking and adjustment of the steering wires Checking and adjusting the brake Check the level of the battery acidCheck the safety system Poorly adjusted brakes can result in reduced braking powerDo not use compressed air to clean the paper filter Replacing the air filterMaintenance Checking and adjusting the cutting unit’s parallelism Dismantling the cutting unit Checking the bladesChanging the oil Lubrication Replacement of the oil filterGeneral lubrication Checking and adjustment of the throttle wire Replacement of the fuel filter Checking the tyre pressureTrouble Shooting Schedule Problem ProcedureStorage ServiceWinter storage Wiring Diagram Technical Data Rider 1030 Bioclip, RiderEnglish «*2h6+¬ English «*2h6+¬