Husqvarna 1030 BioClip, 1200 manual IV. Service

Page 5

SAFETY INSTRUCTIONS

IV. Service

1.Use extra care in handling gasoline and other fuels. They are flammable and vapours are explosive.

a)Use only an approved container.

b)Never remove gas cap or add fuel with the engine running. Allow engine to cool before refuelling. Do not smoke.

c)Never refuel the machine indoors.

d)Never store the machine or fuel container

 

inside where there is an open flame, such as

Danger, keep hands and feet away

 

in a water heater.

 

 

2.

Never run a machine inside a closed area.

 

3.

Keep nuts and bolts, especially blade attach-

 

 

ment bolts, tight and keep equipment in good

 

 

condition.

 

4.

Never tamper with safety devices. Check their

 

 

proper operation regularly.

 

5.

Keep machine free of grass, leaves or other

 

 

debris build-up. Clean up oil or fuel spillage.

 

 

Allow machine to cool before storing.

 

6.

Stop and inspect the equipment if you strike an

 

 

object. Repair, if necessary, before restarting.

 

7.

Never make adjustments or repairs with the

 

 

engine running.

 

8.

Grass catcher components are subject to wear,

 

 

damage and deterioration, which could expose

 

 

moving parts or allow objects to be thrown.

 

 

Frequently check components and replace with

 

 

manufacturer’s recommended parts, when

 

 

necessary.

 

9.

Mower blades are sharp and can cut. Wrap the

 

 

blade(s) or wear gloves and use extra caution

 

 

when servicing them.

 

10.Check brake operation frequently. Adjust and service as required.

English – 3

Image 5
Contents 101 89 Rider 1030 BioClip RiderSvenska Contents Safe operation practices for ride-on mowers Safety InstructionsGeneral operation II. Slope operationIV. Service Read the instructions Explanation of SymbolsGeneral use These instructions are for your safety. Read them carefullyDo as follows Driving on slopesDo not do the following MaintenanceChildren Never drive the machine in an enclosed space Location of the controls PresentationPresentation Speed limiter Throttle controlChoke lever Lift lever for cutting unit Cutting unitParking brake Lever for adjustment of the cutting heightSeat FuellingStarting the engine DrivingBefore starting Driving the machine Cutting tips Disengage lever Stopping the engineMAX Maintenance schedule MaintenanceDaily Maintenance interval HoursEngine hood Dismantling of the machine hoodsFront hood Right-hand fenderChecking of the fuel pump’s air filter Check the engine’s oil levelCheck the engine’s cooling air intake Check the transmission’s oil level Check the transmission’s air intakeChecking and adjustment of the steering wires Check the level of the battery acid Checking and adjusting the brakeCheck the safety system Poorly adjusted brakes can result in reduced braking powerReplacing the air filter Do not use compressed air to clean the paper filterMaintenance Checking and adjusting the cutting unit’s parallelism Checking the blades Dismantling the cutting unitChanging the oil General lubrication Replacement of the oil filterLubrication Checking and adjustment of the throttle wire Checking the tyre pressure Replacement of the fuel filterProblem Procedure Trouble Shooting ScheduleWinter storage ServiceStorage Wiring Diagram Rider 1030 Bioclip, Rider Technical DataEnglish «*2h6+¬ English «*2h6+¬