Husqvarna 1200, 1030 BioClip manual Stopping the engine, Max, Disengage lever

Page 18

DRIVING

!WARNING!

Never drive the machine on ground at an angle of more than 15°. Mow slopes upwards and downwards, never across. Avoid sudden changes in direction.

Stopping the engine

Preferably allow the engine to idle for a minute to obtain normal working temperature before stopping it if it has been working hard.

1.Lift up the cutting unit by pulling the lever back to the locked position.

MAX 15

2.Move the throttle control to the MIN. position. Turn the ignition key to the STOP.

Disengage lever

To move the machine when the engine is switched off the disengage lever must be pulled backwards.

16 – English

Image 18
Contents Rider 1030 BioClip Rider 101 89Svenska Contents General operation Safety InstructionsSafe operation practices for ride-on mowers II. Slope operationIV. Service Explanation of Symbols Read the instructionsThese instructions are for your safety. Read them carefully General useDriving on slopes Do as followsMaintenance ChildrenDo not do the following Never drive the machine in an enclosed space Presentation PresentationLocation of the controls Throttle control Choke leverSpeed limiter Cutting unit Lift lever for cutting unitSeat Lever for adjustment of the cutting heightParking brake FuellingDriving Before startingStarting the engine Driving the machine Cutting tips Stopping the engine MAXDisengage lever Daily Maintenance interval MaintenanceMaintenance schedule HoursFront hood Dismantling of the machine hoodsEngine hood Right-hand fenderCheck the engine’s oil level Check the engine’s cooling air intakeChecking of the fuel pump’s air filter Check the transmission’s air intake Check the transmission’s oil levelChecking and adjustment of the steering wires Check the safety system Checking and adjusting the brakeCheck the level of the battery acid Poorly adjusted brakes can result in reduced braking powerDo not use compressed air to clean the paper filter Replacing the air filterMaintenance Checking and adjusting the cutting unit’s parallelism Dismantling the cutting unit Checking the bladesChanging the oil Replacement of the oil filter LubricationGeneral lubrication Checking and adjustment of the throttle wire Replacement of the fuel filter Checking the tyre pressureTrouble Shooting Schedule Problem ProcedureService StorageWinter storage Wiring Diagram Technical Data Rider 1030 Bioclip, RiderEnglish «*2h6+¬ English «*2h6+¬