STORAGE
PREPARING THE UNIT FOR STORAGE
Water should not remain in the unit for long periods of time. Sediments or minerals can deposit on pump parts and “freeze” pump action. If you do not plan to use the pressure washer for more than 30 days, follow this procedure:
1.Flush detergent siphoning tube by placing the filter into a pail of clean water while running pressure washer in low pressure mode. Flush for one to two minutes.
2.Shut off the engine and let it cool, then remove all hoses. Disconnect spark plug wire from spark plug.
3.Empty the pump of all pumped liquids by pulling the recoil handle about 6 times.This should remove most of the liquid in the pump.
4.Draw RV antifreeze
If available, use PumpSaver in place of RV antifreeze and follow package instructions.
5.Store unit in a clean, dry area.
STORING THE ENGINE
See the engine operator’s manual for instructions on how
to properly prepare the engine for storage.
16