Raypak 992B-1262B manual Clearances, Indoor Installations, Outdoor Installations

In addition, the heater shall be installed such that the gas ignition system components are protected from water (dripping, spraying, rain, etc.) during appliance operation or service (circulator replacement, control replacement, etc.).

Clearances

Indoor Installations

Heater	Minimum Clearance	Recommended
	from Combustible	Service
Side
	Surfaces	Clearance
Floor*	0”	0”
Rear	1”	24”
Water Side	12”	24”
Other Side	1”	24”
Top	1”	1”
Front	Open	24”
Vent	2”	2”

* DO NOT install on carpeting.

Table E: Clearances – Indoor Installations

TOP VIEW

FRONT VIEW

Venting not shown for clarity. Heater must be vented

per instructions in this manual

Fig. 7: Minimum Clearances from Combustible

Surfaces – Indoor Installations

When installed according to the listed minimum clear- ances from combustible construction, these heaters can still be serviced without removing permanent structural construction around the heater. However, for ease of servicing, we recommend a clearance of at least 24 in. in front, and at least 12 in. on the water connection side. This will allow the heater to be serv- iced in its installed location without movement or removal of the heater.

Service clearances less than the minimums may require removal of the heater to service either the heat exchanger or the burner tray. In either case, the heater must be installed in a manner that will enable the heater to be serviced without removing any structure around the heater.

Outdoor Installations

These heaters are design-certified for outdoor installa- tion. Heaters must not be installed under an overhang that is less than 3 ft from the top of the heater. Three sides must be open in the area under the overhang. Roof water drainage must be diverted away from heaters installed under overhangs.

Heater	Min. Clearance	Recommended
	from Combustible	Service
Side
	Surfaces	Clearance
Front	Open	24”
Rear	12”	24”
Water Side	36”	36”
Other Side	36”	36”
Top	Unobstructed	Unobstructed
Vent	N/A	N/A

Table F: Clearances – Outdoor Installations

These clearances are required when the outdoor vent cap is used. If installing the heater outdoors with a vent stack, the indoor clearances may be utilized.

The combustion air intake hood MUST be used for outdoor installations. The hood is shipped loose and installed on the side of the heater over the filter box at the jobsite.

11