ASSEMBLY
6.Place chute assembly onto chute base as shown in Fig. 4,
making sure that the notches engage with the spiral end of chute directional control.
7.Secure flange keeper removed earlier with lock nuts and screws.
Tighten down nuts securing the other two flange keepers. See Fig. 5.
8. If not already done, slip the cables that run from the handle panel to the discharge chute into the cable guide extending over the top of the engine. See Fig. 4.
9.Normally the cable ties holding the steering cables against the handle are loosely installed on each side of the lower handle at the factory. Pull the cable ties tight to secure. Cut the excess
from the ends of cable ties.
The extension cord is fastened with a cable tie to the rear of the auger housing for shipping purposes. Cut the cable tie and remove it before operating the snow thrower.
Set-Up
Chute Clean-Out Tool
A chute
Drift Cutters
1. Remove the two screws and lock nuts that secure each drift cutter, and remove them from the sides of the auger housing.
WARNING
Never use your hands to clear a clogged chute assembly. Shut off engine and remain behind handles until all moving parts have stopped before using the
2.Turn the drift cutters around and position them as shown in Fig. 7 to the outside of the auger housing.
3.Attach the drift cutters with the screws and lock nuts removed earlier.
Figure 7
Figure 4
Figure 5
Chute
Figure 6
9