Teledyne Model 300EU M300EU Addendum to M300E/EM Manual, A-10, Rev K.6, O2FILTPCT, STDO2CELLTEMP

APPENDIX A-2: Setup Variables For Serial I/O, Revision K.6								M300EU Addendum to M300E/EM Manual
	SETUP VARIABLE		NUMERIC			DEFAULT	VALUE RANGE		DESCRIPTION
			UNITS			VALUE
	O2_FILT_PCT	%		2				0.1–100	Relative change in O2 concentration to
									shorten filter.
	O2_FILT_DELAY		Seconds	20				0–300	Delay before leaving O2 adaptive filter mode.
	O2_DIL_FACTOR		—	1				0.1–1000	Dilution factor for O2. Used only if is dilution
									enabled with FACTORY_OPT variable.
	CO2_COMP_ENABLE		—			OFF		ON, OFF	ON enables CO2 compensation; OFF disables
									it.
	CO2_COMP_CONC	%		0				0–20	CO2 concentration to compensate for.
	O2_CELL_SET		ºC		50			30–70	O2 sensor cell temperature set point and
						Warnings:
									warning limits.
						45–55
	STD_O2_CELL_TEMP		ºK	323				1–500	Standard O2 cell temperature for temperature
									compensation.
	ZERO_ENABLE		—			ON, OFF		OFF, ON	ON enables auto-zero calibration using
									scrubber; OFF disables it.
	ZERO_FREQ		Minutes	5				0.1–1440	Auto-zero calibration period.
	CO2_TARG_SPAN_CONC	%		12				0.1–1000	Target CO2 concentration during span
									calibration.
	CO2_SLOPE		—	1				0.5–5	CO2 slope.
	CO2_OFFSET	%		0				-10–10	CO2 offset.
	O2_TARG_SPAN_CONC	%		20.95				0.1–100	Target O2 concentration during span
									calibration.
	O2_SLOPE		—	1				0.5–2	O2 slope.
	O2_OFFSET	%		0				-10–10	O2 offset.
	CO2_RANGE	%		15				0.1–500	CO2 concentration range.
	O2_RANGE	%		100				0.1–500	O2 concentration range.
	O2_CELL_CYCLE		Seconds	10				0.5–30	O2 cell temperature control cycle period.
	O2_CELL_PROP		—	1				0–10	O2 cell PID temperature control proportional
									coefficient.
	O2_CELL_INTEG		—	0.1				0–10	O2 cell PID temperature control integral
									coefficient.
	O2_CELL_DERIV		—			0 (disabled)		0–10	O2 cell PID temperature control derivative
									coefficient.

A-10 05924 Rev K.6