Teledyne Model 300EU manual M300EU Addendum to M300E/EM Manual, Table A-5, A-12, Rev K.6

APPENDIX A-3: Warnings and Test Functions, Revision K.6					M300EU Addendum to M300E/EM Manual
	Table A-5:	Additional or Changed Test Function Relevant to the M300EU , Revision K.6
	TEST FUNCTION		MESSAGE TEXT		DESCRIPTION
	NAME
	STABILITY		STABIL=0.0 PPM	These gases not applicable to the M300EU
	AUTOZERO		AZERO RATIO=1.234	Measure/reference ratio during auto-reference.
	BOXTEMP2		BOX TEMP2=29.6 C	Internal box temperature #2.
	OVENTEMP		OVEN TEMP=30.1 C	Oven temperature

Table A-6: M300E/EM Test Function Not Applicable to the M300EU, Revision K.6

Because the CO2 and O2 sensor options are not available on the M300EU, the following test functions listed in Appendix A-2 of the M300E/EM Operators Manual (P/N 04288) are not present in the M300EU software.

TEST FUNCTION	MESSAGE TEXT		DESCRIPTION
NAME
CO2RANGE	CO2 RANGE=20 % 1	CO2	range.
O2RANGE	O2 RANGE=100 % 2	O2 range.
	CO STB=0.0 PPM 1, 2
[STABILITY]	CO2 STB=0.0 % 1	These gases not applicable to the M300EU
	O2 STB=0.0 % 2
O2CELLTEMP	O2 CELL TEMP=50.2 C	O2 sensor cell temperature.
CO2SLOPE	CO2 SLOPE=1.000	CO2	slope, computed during zero/span calibration.
CO2OFFSET	CO2 OFFSET=0.000	CO2	offset, computed during zero/span calibration.
O2SLOPE	O2 SLOPE=0.980	O2 slope, computed during zero/span calibration.
O2OFFSET	O2 OFFSET=1.79 %	O2 offset, computed during zero/span calibration.

A-12 05924 Rev K.6