Sanyo POA-MD13NET2 owner manual How to enter the numbers, Restart the Network board

For the Projector which provides the Network main menu

Network configuration

2 Configuration for IP Address/ Subnet mask/Default Gateway*/DNS*

Press SELECT button again. The following network setting pallet appears on the screen.

Enter the specified network addresses.

The red frame moves sequentially left or right with 78 button.

The number up or down with de button.

How to enter the numbers

There are 2 ways to enter the numbers, one is by using the point buttons (d e ) on the remote control or on the projector, the other is by using the screen 10-key pallet by which the numbers can be entered directory. For further information see "How to enter the numbers with the screen 10-key pallet" (☞ p.19).

3 Restart the Network board

After completing the entering of address, select "Set" and press SELECT button. The network unit starts re- booting and displays message "Please wait..." on the screen until the re-booting is complete. Do not turn off the mains switch during this period.

Completing of installation

Now the installation is completed. The IP address of this projector is set to “192.168.1.201”.

Item	Description
IP address	..........Sets IP address of the projector
Subnet	Sets Subnet mask. Normally sets 255.255.255.0
Gateway*1	........Sets IP address of the default gateway (Router)
DNS*2	Sets IP address of the DNS server. Must be set when using the e-mail function

*Refer to the projector's owner's manual for operation of the projector.

*1 In the network environments not using a Gateway or Router, the Default Gateway address should be set to [0.0.0.0].

*2 If you do not use the functions E-mail or DNS server, it should also be set to [0.0.0.0] for the DNS address.

Network Board

OWNER’S MANUAL

ENGLISH

17