For the Projector which provides the Network sub menu in the Setting main menu
Network configuration
2 Configuration for IP Address/ Subnet mask/Default Gateway*/DNS*
Press the SELECT button again, the following network setting menu appears on the screen. Enter the specified network address with the point buttons (d e 7 8). The following is an example of a network configuration.
NETWORK SETTING |
|
|
|
|
|
| |||
IP Address | 192 |
|
| 168 |
| 1 |
| 201 |
|
Sub net | 255 |
|
| 255 |
| 255 |
| 0 |
|
Gateway | 192 |
|
| 168 |
| 1 |
| 1 |
|
DNS | 0 |
|
| 0 |
| 0 |
| 0 |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| SET |
| CANCEL |
|
|
|
|
|
|
|
|
|
|
|
How to enter the numbers
To move the selection and change the values, use the point buttons (d e 7 8) on the projector or on the remote control.
The point buttons 7 8are used to select the column.
The point buttons de are used to change the numbers up and down.
3 Restart the Network board
Select the SET with the point buttons ( 7 8) and press the SELECT button again. The network configuration display disappears and the network board begins restarting*1. It takes about 40 seconds. Do not turn off the mains switch during this period.
Completing of installation
Now the installation is completed. The IP address of this projector is set to “192.168.1.201”.
*In the network environments not using a Gateway or Router, the Default Gateway address should be set to [0.0.0.0]. If you do not use the functions
Network Board
OWNER’S MANUAL
ENGLISH
21