Chapter 3 Basic Setting and Operation
E-mail Setting
This product has an E-mail function which can send an alert message to users or an administrator if it detects an abnormality on the projector or run out of the life span of the lamp. Click on the E-Mail Setting linked text on the main
menu and follow the below steps.
1Registering SMTP Server*1, Administrator Address
Type the E-mail address of SMTP server and administrator and press the Set but- ton. The administrator address is set to "Reply-To" address sent from the projector.
*1 The SMTP server is a server for sending E-mail. Please contact your network administra- tor to have this SMTP server address.
*If the network board sends an alert message due to the abnormality on the projector but the SMTP server is down in some reason, the message will not be sent. In this case, the message "Unable to connect to server" will be displayed on this page. To clear this message, click the Set button.
✐To use the E-mail function, it must be set the DNS address on the Network Setting page correctly.
✐You cannot use this E-mail function if the DNS server and SMTP server cannot be used in your network environment. If the SMTP server is located in your LAN (Local Area network), the address set to SMTP server should be specified in the SMTP server located in your LAN. The server located outside of your LAN may not be available for security reason. For further information please contact your network administrator.
✐Up to 10 e-mail addresses can be registered.