Sanyo POA-MD13NET2 owner manual Check the status of projector, Items Description

Check the status of projector

Check the status of projector

In the “Power & Status” page, you can control the projector power, and also you can check the status of the projector as follows. To change the page, click on the page number linked text.

Items	Description
Lamp Mode		Displays 2 lamps or 4 lamps mode and lamp status as below icons with
		Lamp1/Lamp2/Lamp3/Lamp4 order.
			Yellow	Red
			....................Normal	....................Lamp replacement required
			Gray	Gray with X
			....................Off	....................Abnormality of the lamp
Accumulated
Lamp-use Time		Displays the accumulated lamp use time in hour units (h) and displays each
		time with Lamp1/Lamp2/Lamp3/Lamp4 order.
Accumulated
Projector-use Time		Displays the accumulated projector use time in hour unit (h).
Power Status		Displays the status of the lamp.
Projector Condition*		Displays the status of the projector's power.

*When occurring the internal power failure, The word “Power Failure” and error information is displayed.

Input Status	Displays the selected input.
Selection	Displays the selected input mode.
Signal Status	Displays the signal status of the selected input mode.
Inside temperature	Displays the internal temperature of the projector. The icons [A], [B], [C] on
	the page represent the thermal sensors*2 located in the projector. If the tem-
	perature at one of those sensors exceeds specified temperature, the appear-
	ance of its icon changes to the following alert icon to let users know about
	the abnormal temperature. Please check surrounding temperature of the pro-
	jector, check for clogged air filters and check area surrounding the ventilation
	fans.

The icons [A] , [B] and [C] represent the sensors located in the projector as follows: [A]: Surrounding temperature of the projector*1

[B]: Internal temperature of the projector

[C]: Internal temperature of the projector*2

*1 The indicated peripheral temperature of the projector is a little higher than actual surrounding tem- perature.

*2 Sensor C icon may not indicated depending on the projector's model type.

Network Board

OWNER’S MANUAL

ENGLISH

37