Xerox DocuPrint C6 manual Safety notes

Page 10

Safety notes

Your DocuPrint C6 has been carefully designed to give you years of safe, reliable performance. As with all electrical equipment, however, there are a few basic precautions you should take to avoid hurting yourself or damaging the unit.

1.Read and follow all warnings and instructions marked on or supplied with the printer.

2.Unplug the printer before you clean it. Use a damp cloth only; do not use liquid or aerosol cleaners.

3.Place your printer on a firm, solid surface. If you put it on an unsteady surface, it might fall and become damaged. If you place the printer on a soft surface, such as a rug, sofa, or bed, the vents may be blocked, causing it to overheat.

4.Do not put the printer on or near a heat source, such as a radiator or heat register. If you put the printer in any kind of enclosure, make sure it is well ventilated.

5.Do not use your printer near water, or spill liquid of any kind into it.

6.Ensure that your power source matches the rating listed on the back of the printer.

7.Be sure to install the printer near a power outlet that will remain easily accessible.

8.To avoid damaging the power cord, do not put anything on it or place it where it will be walked on. If the cord becomes damaged or frayed, replace it immediately.

2

Image 10

Contents DocuPrint C6 Inkjet Printer Publication number 701P31015 Customer Support Page Contents Troubleshooting the printer Selecting and Ordering Supplies IndexPage Introduction Safety notes Page Page Page Printer Registration Directions for On-Line RegistrationUnderstanding the Printer’s Features Hardware features Inside view of DocuPrint C6 Printer Rear view of DocuPrint C6 Printer Control Panel Operation LED OffPrinter Error Conditions LED On ContinuouslyLED Blinking Intermittently 0.2 sec On, 1.4 sec Off Printer specifications Feature SpecificationFeature Specification System Requirements Printable area / Margins Recommended PossiblePage From a Windows software application Accessing printer settingsFrom the Printers folder for Windows 95/98 Copies Paper/Output PropertyOrientation Order CollateReverse print Print documentPrint quality Saved settingsSave As Delete Default AllDefaults from the Saved settings StatusLayout Property Print crop marks DefaultsNumber of sheets Print sheetsSelect Sheets Page Multiple-up option Mirror Image NoneImage Quality Property ImageFixä∙ Fine dither ∙ Quality airbrush ∙ Sharp airbrush Green RedDocument as is set to Greyscale BlueAbout Property Status Property Cartridge Mimic Information areaNow printing Copy Percent completeMaintenance Property Change ∙ Previously used print cartridge Align CleanAlignment Test Pattern if you want to Print the Alignment Test Pattern Checking the documents in the print queue Troubleshooting the printer Cause Suggested Solution Printed document is blank Cause Suggested Solution Document prints slowly Draft or NormalDocument sent to the printer does not print Front Panel LED is on continuously Page Front Panel LED is blinking slowly Front Panel LED is blinking intermittentlyPrint is blurry or jagged vertical lines appear Printed image is clipped or off the edge of the media Cause Suggested Solution Cause Suggested Solution Print is faint or missing To DraftInk is smeared on the printed pages Print quality of transparencies is poor Color variations appear in large areas of color Paper is not feeding properly Paper does not stack neatly in the paper output shelf Packing the printer for return to a Service Center Printer Page Selecting and Ordering Supplies Selecting plain paper Cartridges and print headsDescription Reorder Number Paper weights Selecting specialty print mediaSelecting banner paper Selecting labelsSelecting transparencies Selecting envelopesIndex