Xerox DocuPrint C6 manual Paper does not stack neatly in the paper output shelf

Page 69

The paper does not stack neatly in the paper output shelf

Cause	Suggested Solution

There is not enough clearance above the paper output shelf.

Place a sheet of paper in the paper output shelf. Check the clearance above the top of the sheet; there should be two inches of clearance.

The star wheel assembly bar is disengaged.

Open the printer cover. Reinstall the star wheel bar by pushing down on each end of the bar until it snaps into position.

The star wheels are out of position in the star wheel assembly.

Open the printer cover. Lift the star wheel bar by grasping each end of the bar and rotating it toward the back of the printer. Make sure the small wheels in the star wheel assembly are not pushed all the way inside the rectangular slots and are able to rotate freely. Then reinstall the star wheel bar and close the printer cover.

61

Image 69

Contents DocuPrint C6 Inkjet Printer Publication number 701P31015 Customer Support Page Contents Troubleshooting the printer Index Selecting and Ordering SuppliesPage Introduction Safety notes Page Page Page Directions for On-Line Registration Printer RegistrationUnderstanding the Printer’s Features Hardware features Inside view of DocuPrint C6 Printer Rear view of DocuPrint C6 Printer LED Off Control Panel OperationLED On Continuously Printer Error ConditionsLED Blinking Intermittently 0.2 sec On, 1.4 sec Off Feature Specification Printer specificationsFeature Specification System Requirements Recommended Possible Printable area / MarginsPage Accessing printer settings From a Windows software applicationFrom the Printers folder for Windows 95/98 Paper/Output Property CopiesOrientation Reverse print CollateOrder Print documentSaved settings Print qualitySave As Defaults from the Saved settings Default AllDelete StatusLayout Property Number of sheets DefaultsPrint crop marks Print sheetsSelect Sheets Page Multiple-up option None Mirror ImageImageFixä Image Quality Property∙ Fine dither ∙ Quality airbrush ∙ Sharp airbrush Document as is set to Greyscale RedGreen BlueAbout Property Status Property Information area Cartridge MimicNow printing Percent complete CopyMaintenance Property Change ∙ Previously used print cartridge Clean AlignAlignment Test Pattern if you want to Print the Alignment Test Pattern Checking the documents in the print queue Troubleshooting the printer Cause Suggested Solution Printed document is blank Cause Suggested Solution Draft or Normal Document prints slowlyDocument sent to the printer does not print Front Panel LED is on continuously Page Front Panel LED is blinking intermittently Front Panel LED is blinking slowlyPrint is blurry or jagged vertical lines appear Printed image is clipped or off the edge of the media Cause Suggested Solution Cause Suggested Solution To Draft Print is faint or missingInk is smeared on the printed pages Print quality of transparencies is poor Color variations appear in large areas of color Paper is not feeding properly Paper does not stack neatly in the paper output shelf Packing the printer for return to a Service Center Printer Page Selecting and Ordering Supplies Cartridges and print heads Selecting plain paperDescription Reorder Number Selecting specialty print media Paper weightsSelecting transparencies Selecting labelsSelecting banner paper Selecting envelopesIndex