Xerox DocuPrint C6 manual Print quality of transparencies is poor

Page 66

The print quality of transparencies is poor

Cause

Suggested Solution

The wrong type of transparencies was used.

Transparency is not selected for the Paper type option on the Paper/Output property page.

Use transparencies made for ink jet printers only.

Make sure Transparency is the selected Paper type option on the Paper/Output property page. If the problem continues, select the Page Setup command from the application that you are using to open the Paper/Output property page, and select the Transparency option located in Paper type.

The document was printed on the wrong side of the transparency film.

Remove the transparencies from the paper tray, turn the sheets over, and reinstall the sheets in the tray. Refer to the instructions for the transparency to see which side is the printable side.

Multiple transparencies are	When printing multiple
stacked in the paper output shelf.	transparencies, remove each
	transparency from the paper
	output shelf after it has been
	printed.

58

Image 66

Contents DocuPrint C6 Inkjet Printer Publication number 701P31015 Customer Support Page Contents Troubleshooting the printer Selecting and Ordering Supplies IndexPage Introduction Safety notes Page Page Page Printer Registration Directions for On-Line RegistrationUnderstanding the Printer’s Features Hardware features Inside view of DocuPrint C6 Printer Rear view of DocuPrint C6 Printer Control Panel Operation LED OffPrinter Error Conditions LED On ContinuouslyLED Blinking Intermittently 0.2 sec On, 1.4 sec Off Printer specifications Feature SpecificationFeature Specification System Requirements Printable area / Margins Recommended PossiblePage Accessing printer settings From a Windows software applicationFrom the Printers folder for Windows 95/98 Paper/Output Property CopiesOrientation Order CollateReverse print Print documentSaved settings Print qualitySave As Delete Default AllDefaults from the Saved settings StatusLayout Property Print crop marks DefaultsNumber of sheets Print sheetsSelect Sheets Page Multiple-up option Mirror Image NoneImage Quality Property ImageFixä∙ Fine dither ∙ Quality airbrush ∙ Sharp airbrush Green RedDocument as is set to Greyscale BlueAbout Property Status Property Information area Cartridge MimicNow printing Copy Percent completeMaintenance Property Change ∙ Previously used print cartridge Clean AlignAlignment Test Pattern if you want to Print the Alignment Test Pattern Checking the documents in the print queue Troubleshooting the printer Cause Suggested Solution Printed document is blank Cause Suggested Solution Document prints slowly Draft or NormalDocument sent to the printer does not print Front Panel LED is on continuously Page Front Panel LED is blinking slowly Front Panel LED is blinking intermittentlyPrint is blurry or jagged vertical lines appear Printed image is clipped or off the edge of the media Cause Suggested Solution Cause Suggested Solution Print is faint or missing To DraftInk is smeared on the printed pages Print quality of transparencies is poor Color variations appear in large areas of color Paper is not feeding properly Paper does not stack neatly in the paper output shelf Packing the printer for return to a Service Center Printer Page Selecting and Ordering Supplies Cartridges and print heads Selecting plain paperDescription Reorder Number Paper weights Selecting specialty print mediaSelecting banner paper Selecting labelsSelecting transparencies Selecting envelopesIndex