Xerox DocuPrint C6 manual Document sent to the printer does not print

Page 56

The document sent to the printer does not print

Cause

Suggested Solution

The printer cable is not connected properly.

Unplug the power source. Make sure the printer cable is securely connected to the printer and your PC. Reconnect the power source.

The printer is not mapped to the local port.

Map the printer to LPT1. Use the Windows Details property page to map the LPT printer port. Click the <Start> button, point to Settings, and click Printers. Click the Xerox DocuPrint C6 icon with the right mouse button, then click Properties. Click the Details tab, and check the Print to the following port. The printer port is usually LPT1.

The printer cable is incorrect.

Use an IEEE 1284 compliant parallel printer cable.

The printer cable is damaged.

Check the printer cable and replace if damaged.

The type of interface is incorrect. Verify that the computer is using the parallel interface. Check your Windows software manual to ensure that your operating system software communicates to the interface port that your printer is connected to.

The front panel LED is blinking intermittently.

Press and release the Printer Control (green) button to continue printing.

48

Image 56

Contents DocuPrint C6 Inkjet Printer Publication number 701P31015 Customer Support Page Contents Troubleshooting the printer Selecting and Ordering Supplies IndexPage Introduction Safety notes Page Page Page Printer Registration Directions for On-Line RegistrationUnderstanding the Printer’s Features Hardware features Inside view of DocuPrint C6 Printer Rear view of DocuPrint C6 Printer Control Panel Operation LED OffPrinter Error Conditions LED On ContinuouslyLED Blinking Intermittently 0.2 sec On, 1.4 sec Off Printer specifications Feature SpecificationFeature Specification System Requirements Printable area / Margins Recommended PossiblePage From the Printers folder for Windows 95/98 Accessing printer settingsFrom a Windows software application Orientation Paper/Output PropertyCopies Collate Reverse printOrder Print documentSave As Saved settingsPrint quality Default All Defaults from the Saved settingsDelete StatusLayout Property Defaults Number of sheetsPrint crop marks Print sheetsSelect Sheets Page Multiple-up option Mirror Image NoneImage Quality Property ImageFixä∙ Fine dither ∙ Quality airbrush ∙ Sharp airbrush Red Document as is set to GreyscaleGreen BlueAbout Property Status Property Now printing Information areaCartridge Mimic Copy Percent completeMaintenance Property Change ∙ Previously used print cartridge Alignment Test Pattern if you want to CleanAlign Print the Alignment Test Pattern Checking the documents in the print queue Troubleshooting the printer Cause Suggested Solution Printed document is blank Cause Suggested Solution Document prints slowly Draft or NormalDocument sent to the printer does not print Front Panel LED is on continuously Page Front Panel LED is blinking slowly Front Panel LED is blinking intermittentlyPrint is blurry or jagged vertical lines appear Printed image is clipped or off the edge of the media Cause Suggested Solution Cause Suggested Solution Print is faint or missing To DraftInk is smeared on the printed pages Print quality of transparencies is poor Color variations appear in large areas of color Paper is not feeding properly Paper does not stack neatly in the paper output shelf Packing the printer for return to a Service Center Printer Page Selecting and Ordering Supplies Description Reorder Number Cartridges and print headsSelecting plain paper Paper weights Selecting specialty print mediaSelecting labels Selecting transparenciesSelecting banner paper Selecting envelopesIndex