Xerox 721P manual Roll 3 only

Page 27

MEDIA

10.Insert the lead edge of the media between the upper and lower feed rollers.

11.Rotate the lower roller by hand in order to feed an inch (25 mm) of media between the rollers.

Roll 3 only:

12.Rotate the lower feed roller until the lead edge is visible in the center of the viewing hole.

841

Plain

paper

Tracing

paper

Film

Belt

13.Set the switches for the series and type of media you have loaded, from rear to front:

Arch. (12”, 18”, 24”, 30”, 36”, rolls) or Ansi. (11”, 17”, 22”, 34" rolls)….(Rear)

Plain Media

Vellum

Film

(Front)

NOTE:

14.Ensure that the rubber-tracking belt is underneath the plastic roller on the right side of the media spindle. If the belt is not correctly positioned, the printer will indicate an out-of-media condition.

15.Push in the drawer until it is closed and latched.

16.If the leading edge is not sufficiently square, perform the automatic initial cut by pressing the [Select] key to select the appropriate drawer, and then pressing [Cut] key. Approximately 9.5” (240mm) media will be cut and fed from the printer.

XEROX WIDE FORMAT 721P PRINTER OPERATOR MANUAL

19

Image 27

Contents Xerox Wide Format 721P Printer Operator Manual Page Table of contents User Modes Safety Notes Introduction Canada EMC NoticesAustralia/New Zealand European UnionUSA JapanIntroduction IntroductionTerminology Used In This Manual Organization And Content Of This ManualBold Conventions Used In This ManualThis page is intentionally blank Product Specifications SpecificationMedia Specifications Room Air Change Requirements For Ozone Dissipation Room Space RequirementsSerial Number Location Room Space RequirementsThis page is intentionally blank Printer Orientation Printer OverviewMain Components Rear Side View Pins Not UsedPins Service use onlyPrinter Overview Operator Panel & Status Display Ready IndicatorUse Indicators Media and Toner Status PanelRoll Size Displays Displays the size of the roll media Online/Offline Job Cancel Adding Media Rolls MediaLoading The Roll Media Roll 1, 2 Roll 3 only Loading The Roll Media Roll Belt Loading The Roll Media When Printing Dehumidifier Using Manual Bypass Feed Care When The Toner Cartridge Needs ReplacementReplacing The Toner Cartridge Sealed opening Wire-Clean Cleaning The Charge Scorotron WireExp-Clean Cleaning The LED Print HeadCleaning The Printer Surface Supply order procedure Ordering suppliesSupply order list This page is intentionally blank Media Jams Problem SolvingClearing Media Jam J-01 & J-02 Problem Solving Clearing Media Jam J-03 Problem Solving Clearing Media Jam J-04 Green Knob Clearing Media Jam J-05 Clearing Media Jam J-11 & J-12 Slit Clearing Media Jam J-13 & J-14 Clearing Media Jam J-22 Error Codes Printer Errors E-XXError Code Cause Treatment Thumping Noise in Standby Door Open Errors U-XXProblem Cause Solution Image Quality Problem SolvingThis page is intentionally blank User Modes User Mode 1 Test Print U1User Modes User Mode 2 Date and Time setting U2 Hour Minute Second User Mode 3 Low Power Saver Mode U3 User Modes User Mode 4 High Power Saver Mode U4 User Modes User Mode 5 Media Cut At Power on U5 User Mode 6 Detack Lamp Control Mode U6 User Mode 7 Attention Beeper Enable Mode U7 User Mode 8 Custom Setting Plain Paper U8 User Mode 9 Custom Setting Vellum/Tracing Paper U9 User Mode a Custom Setting Film UA User Mode b Image Enhancement Ub 701P39415 4/2003 USA