Xerox 721P manual Sealed opening

Page 35

CARE

4.Shake the new cartridge several times in order to prepare the contents for use and remove the foam band from the cartridge.

DO NOT apply pressure to the center of the cartridge. Toner will spill from the ends of the cartridge.

Sealed opening

5.Install the cartridge into the toner supply mechanism while keeping the sealed opening on the upper side of the cartridge.

6.Close the toner supply mechanism.

7.Rotate the toner cartridge 90 degrees as shown to access the seal, then gently remove the seal by pulling to the left.

NOTE: If the cartridge is in any other position, toner will spill from the cartridge.

8.Continue to rotate the toner cartridge to it’s full down position.

9.Close the Left Door.

Status Code U-06 will go out.

The Toner Level Display on the front panel will scroll until the new level is read. Then the new toner level will be displayed.

10.Dispose of the empty cartridge properly by sealing the opening of the cartridge with tape or put the cartridge in a plastic bag before discarding.

XEROX WIDE FORMAT 721P PRINTER OPERATOR MANUAL

27

Image 35

Contents Xerox Wide Format 721P Printer Operator Manual Page Table of contents User Modes Safety Notes Introduction Canada EMC NoticesAustralia/New Zealand European UnionUSA JapanIntroduction IntroductionTerminology Used In This Manual Organization And Content Of This ManualBold Conventions Used In This ManualThis page is intentionally blank Product Specifications SpecificationMedia Specifications Room Air Change Requirements For Ozone Dissipation Room Space RequirementsSerial Number Location Room Space RequirementsThis page is intentionally blank Printer Orientation Printer OverviewMain Components Rear Side View Pins Not UsedPins Service use onlyPrinter Overview Operator Panel & Status Display Ready IndicatorRoll Size Displays Displays the size of the roll media Use IndicatorsMedia and Toner Status Panel Online/Offline Job Cancel Adding Media Rolls MediaLoading The Roll Media Roll 1, 2 Roll 3 only Loading The Roll Media Roll Belt Loading The Roll Media When Printing Dehumidifier Using Manual Bypass Feed Care When The Toner Cartridge Needs ReplacementReplacing The Toner Cartridge Sealed opening Wire-Clean Cleaning The Charge Scorotron WireExp-Clean Cleaning The LED Print HeadCleaning The Printer Surface Supply order list Supply order procedureOrdering supplies This page is intentionally blank Media Jams Problem SolvingClearing Media Jam J-01 & J-02 Problem Solving Clearing Media Jam J-03 Problem Solving Clearing Media Jam J-04 Green Knob Clearing Media Jam J-05 Clearing Media Jam J-11 & J-12 Slit Clearing Media Jam J-13 & J-14 Clearing Media Jam J-22 Error Code Cause Treatment Error CodesPrinter Errors E-XX Thumping Noise in Standby Door Open Errors U-XXProblem Cause Solution Image Quality Problem SolvingThis page is intentionally blank User Modes User Mode 1 Test Print U1User Modes User Mode 2 Date and Time setting U2 Hour Minute Second User Mode 3 Low Power Saver Mode U3 User Modes User Mode 4 High Power Saver Mode U4 User Modes User Mode 5 Media Cut At Power on U5 User Mode 6 Detack Lamp Control Mode U6 User Mode 7 Attention Beeper Enable Mode U7 User Mode 8 Custom Setting Plain Paper U8 User Mode 9 Custom Setting Vellum/Tracing Paper U9 User Mode a Custom Setting Film UA User Mode b Image Enhancement Ub 701P39415 4/2003 USA