Xerox 721P manual User Mode 6 Detack Lamp Control Mode U6

Page 66

USER MODES

User Mode 6 (Detack Lamp Control Mode) “U6”

If the print quality of prints made on Film media lack sharpness or have a light overall appearance, a Detack Lamp in the print process can be switched OFF using Mode 6. This action increases the amount of Toner transferred to the print.

NOTE: If a higher than normal jam rate is experienced, the Detack

Lamp may have to be switched on again.

1.With the printer in the Standby (idle) condition, press the [Menu] Key 6 times to enter Mode 6.

Menu

Enter

Online

.

Press [Menu] 6 times

Menu

Enter

Online

Menu

Enter

Online

Menu

Enter

Online

The [Menu] Key lights and the display indicates “U6” on the left side of the display and the current setting on the right side.

2.Press [Enter]

3.Press the [ ￿ or ￿ ] key to change the value to 0 (OFF)

The value in the display will change to 0 (OFF)

The range is 1 – On and 0 - Off

NOTE: Factory default is “0”, Off.

4. Press the [Online] Key to exit the User Mode.

58

XEROX WIDE FORMAT 721P PRINTER OPERATOR MANUAL

Image 66
Contents Xerox Wide Format 721P Printer Operator Manual Page Table of contents User Modes Safety Notes Introduction European Union EMC NoticesAustralia/New Zealand CanadaJapan USAIntroduction IntroductionOrganization And Content Of This Manual Terminology Used In This ManualConventions Used In This Manual BoldThis page is intentionally blank Specification Product SpecificationsMedia Specifications Room Space Requirements Room Space RequirementsSerial Number Location Room Air Change Requirements For Ozone DissipationThis page is intentionally blank Printer Overview Printer OrientationMain Components Service use only Pins Not UsedPins Rear Side ViewPrinter Overview Ready Indicator Operator Panel & Status DisplayUse Indicators Media and Toner Status PanelRoll Size Displays Displays the size of the roll media Online/Offline Job Cancel Media Adding Media RollsLoading The Roll Media Roll 1, 2 Roll 3 only Loading The Roll Media Roll Belt Loading The Roll Media When Printing Dehumidifier Using Manual Bypass Feed When The Toner Cartridge Needs Replacement CareReplacing The Toner Cartridge Sealed opening Cleaning The Charge Scorotron Wire Wire-CleanCleaning The LED Print Head Exp-CleanCleaning The Printer Surface Supply order procedure Ordering suppliesSupply order list This page is intentionally blank Problem Solving Media JamsClearing Media Jam J-01 & J-02 Problem Solving Clearing Media Jam J-03 Problem Solving Clearing Media Jam J-04 Green Knob Clearing Media Jam J-05 Clearing Media Jam J-11 & J-12 Slit Clearing Media Jam J-13 & J-14 Clearing Media Jam J-22 Error Codes Printer Errors E-XXError Code Cause Treatment Door Open Errors U-XX Thumping Noise in StandbyImage Quality Problem Solving Problem Cause SolutionThis page is intentionally blank User Mode 1 Test Print U1 User ModesUser Modes User Mode 2 Date and Time setting U2 Hour Minute Second User Mode 3 Low Power Saver Mode U3 User Modes User Mode 4 High Power Saver Mode U4 User Modes User Mode 5 Media Cut At Power on U5 User Mode 6 Detack Lamp Control Mode U6 User Mode 7 Attention Beeper Enable Mode U7 User Mode 8 Custom Setting Plain Paper U8 User Mode 9 Custom Setting Vellum/Tracing Paper U9 User Mode a Custom Setting Film UA User Mode b Image Enhancement Ub USA 701P39415 4/2003