Xerox 721P manual Japan, Usa

Page 8

INTRODUCTION

Japan

This is a Class A product based on the standard of the Voluntary Control Council for Interference by Information Technology Equipment (VCCI). If this equipment is used in a domestic environment, radio disturbance may arise. When such trouble occurs, the user may be required to take corrective actions.

Changes or modifications to this equipment not specifically approved by Fuji XEROX Limited may void the user’s authority to operate this equipment.

Shielded cables must be used with this equipment to maintain compliance with the Voluntary Control Council for Interference by Information Technology Equipment regulations.

USA

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

Changes or modifications to this equipment not specifically approved by the XEROX Corporation may void the user’s authority to operate this equipment.

Shielded cables must be used with this equipment to maintain compliance with FCC regulations.

viii	XEROX WIDE FORMAT 721P PRINTER OPERATOR MANUAL

Image 8

Contents Xerox Wide Format 721P Printer Operator Manual Page Table of contents User Modes Safety Notes Introduction EMC Notices Australia/New ZealandEuropean Union CanadaJapan USAIntroduction IntroductionOrganization And Content Of This Manual Terminology Used In This ManualConventions Used In This Manual BoldThis page is intentionally blank Specification Product SpecificationsMedia Specifications Room Space Requirements Serial Number LocationRoom Space Requirements Room Air Change Requirements For Ozone DissipationThis page is intentionally blank Printer Overview Printer OrientationMain Components Pins Not Used PinsService use only Rear Side ViewPrinter Overview Ready Indicator Operator Panel & Status DisplayRoll Size Displays Displays the size of the roll media Use IndicatorsMedia and Toner Status Panel Online/Offline Job Cancel Media Adding Media RollsLoading The Roll Media Roll 1, 2 Roll 3 only Loading The Roll Media Roll Belt Loading The Roll Media When Printing Dehumidifier Using Manual Bypass Feed When The Toner Cartridge Needs Replacement CareReplacing The Toner Cartridge Sealed opening Cleaning The Charge Scorotron Wire Wire-CleanCleaning The LED Print Head Exp-CleanCleaning The Printer Surface Supply order list Supply order procedureOrdering supplies This page is intentionally blank Problem Solving Media JamsClearing Media Jam J-01 & J-02 Problem Solving Clearing Media Jam J-03 Problem Solving Clearing Media Jam J-04 Green Knob Clearing Media Jam J-05 Clearing Media Jam J-11 & J-12 Slit Clearing Media Jam J-13 & J-14 Clearing Media Jam J-22 Error Code Cause Treatment Error CodesPrinter Errors E-XX Door Open Errors U-XX Thumping Noise in StandbyImage Quality Problem Solving Problem Cause SolutionThis page is intentionally blank User Mode 1 Test Print U1 User ModesUser Modes User Mode 2 Date and Time setting U2 Hour Minute Second User Mode 3 Low Power Saver Mode U3 User Modes User Mode 4 High Power Saver Mode U4 User Modes User Mode 5 Media Cut At Power on U5 User Mode 6 Detack Lamp Control Mode U6 User Mode 7 Attention Beeper Enable Mode U7 User Mode 8 Custom Setting Plain Paper U8 User Mode 9 Custom Setting Vellum/Tracing Paper U9 User Mode a Custom Setting Film UA User Mode b Image Enhancement Ub USA 701P39415 4/2003