Xerox 721P manual Belt

Page 29

MEDIA

Knob

841

Plain

paper

Tracing

paper

Film

Belt

9.Insert the lead edge of the media between the upper and lower feed rollers.

10.Rotate the green knob in order to feed an inch (25 mm) of media between the feed rollers.

11.Set the switches for the series and type of media you have loaded, from rear to front:

Arch. (12”, 18”, 24”, 30”, 36”, rolls) or Ansi. (11”, 17”, 22”, 34" rolls) (Rear)

Plain Media

Vellum

Film

(Front)

NOTE:

12.Ensure that the rubber-tracking belt is underneath the plastic roller on the right side of the media spindle. If the belt is not correctly positioned, the printer will indicate an out-of-media condition.

13.Push the drawer in until it is closed and latched.

14.If the leading edge is not sufficiently square, perform the automatic Initial Cut by pressing the [Select] key to select the appropriate drawer, and then pressing [Cut] key. Approximately 9.5” (240mm) media will be cut and fed from the printer.

XEROX WIDE FORMAT 721P PRINTER OPERATOR MANUAL

21

Image 29

Contents Xerox Wide Format 721P Printer Operator Manual Page Table of contents User Modes Safety Notes Introduction Australia/New Zealand EMC NoticesEuropean Union CanadaUSA JapanIntroduction IntroductionTerminology Used In This Manual Organization And Content Of This ManualBold Conventions Used In This ManualThis page is intentionally blank Product Specifications SpecificationMedia Specifications Serial Number Location Room Space RequirementsRoom Space Requirements Room Air Change Requirements For Ozone DissipationThis page is intentionally blank Printer Orientation Printer OverviewMain Components Pins Pins Not UsedService use only Rear Side ViewPrinter Overview Operator Panel & Status Display Ready IndicatorRoll Size Displays Displays the size of the roll media Use IndicatorsMedia and Toner Status Panel Online/Offline Job Cancel Adding Media Rolls MediaLoading The Roll Media Roll 1, 2 Roll 3 only Loading The Roll Media Roll Belt Loading The Roll Media When Printing Dehumidifier Using Manual Bypass Feed Care When The Toner Cartridge Needs ReplacementReplacing The Toner Cartridge Sealed opening Wire-Clean Cleaning The Charge Scorotron WireExp-Clean Cleaning The LED Print HeadCleaning The Printer Surface Supply order list Supply order procedureOrdering supplies This page is intentionally blank Media Jams Problem SolvingClearing Media Jam J-01 & J-02 Problem Solving Clearing Media Jam J-03 Problem Solving Clearing Media Jam J-04 Green Knob Clearing Media Jam J-05 Clearing Media Jam J-11 & J-12 Slit Clearing Media Jam J-13 & J-14 Clearing Media Jam J-22 Error Code Cause Treatment Error CodesPrinter Errors E-XX Thumping Noise in Standby Door Open Errors U-XXProblem Cause Solution Image Quality Problem SolvingThis page is intentionally blank User Modes User Mode 1 Test Print U1User Modes User Mode 2 Date and Time setting U2 Hour Minute Second User Mode 3 Low Power Saver Mode U3 User Modes User Mode 4 High Power Saver Mode U4 User Modes User Mode 5 Media Cut At Power on U5 User Mode 6 Detack Lamp Control Mode U6 User Mode 7 Attention Beeper Enable Mode U7 User Mode 8 Custom Setting Plain Paper U8 User Mode 9 Custom Setting Vellum/Tracing Paper U9 User Mode a Custom Setting Film UA User Mode b Image Enhancement Ub 701P39415 4/2003 USA