Xerox 721P manual EMC Notices, Australia/New Zealand, European Union, Canada

Page 7

INTRODUCTION

EMC Notices

Australia/New Zealand

Changes or modifications to this equipment not specifically approved by Fuji XEROX Australia PTA. Limited may void the user’s authority to operate this equipment.

Shielded cables must be used with this equipment to maintain compliance with the Radio communications Act 1992.

European Union

WARNING

This is a Class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures.

Changes or modifications to this equipment not specifically approved by XEROX Europe may void the user’s authority to operate this equipment.

Shielded cables must be used with this equipment to maintain compliance with the EMC Directive (89/336/EEC).

WARNING

In order to allow this equipment to operate in proximity to Industrial, Scientific and Medical (ISM) equipment, the external radiation from ISM equipment may have to be limited or special mitigation measures taken.

Canada

This Class "A" digital apparatus complies with Canadian ICES- 0003.

Cet appareil numérique de la classe "A" est conforme à la norme NMB-003 du Canada.

XEROX WIDE FORMAT 721P PRINTER OPERATOR MANUAL

vii

Image 7

Contents Xerox Wide Format 721P Printer Operator Manual Page Table of contents User Modes Safety Notes Introduction Canada EMC NoticesAustralia/New Zealand European UnionUSA JapanIntroduction IntroductionTerminology Used In This Manual Organization And Content Of This ManualBold Conventions Used In This ManualThis page is intentionally blank Product Specifications SpecificationMedia Specifications Room Air Change Requirements For Ozone Dissipation Room Space RequirementsSerial Number Location Room Space RequirementsThis page is intentionally blank Printer Orientation Printer OverviewMain Components Rear Side View Pins Not UsedPins Service use onlyPrinter Overview Operator Panel & Status Display Ready IndicatorMedia and Toner Status Panel Use IndicatorsRoll Size Displays Displays the size of the roll media Online/Offline Job Cancel Adding Media Rolls MediaLoading The Roll Media Roll 1, 2 Roll 3 only Loading The Roll Media Roll Belt Loading The Roll Media When Printing Dehumidifier Using Manual Bypass Feed Care When The Toner Cartridge Needs ReplacementReplacing The Toner Cartridge Sealed opening Wire-Clean Cleaning The Charge Scorotron WireExp-Clean Cleaning The LED Print HeadCleaning The Printer Surface Ordering supplies Supply order procedureSupply order list This page is intentionally blank Media Jams Problem SolvingClearing Media Jam J-01 & J-02 Problem Solving Clearing Media Jam J-03 Problem Solving Clearing Media Jam J-04 Green Knob Clearing Media Jam J-05 Clearing Media Jam J-11 & J-12 Slit Clearing Media Jam J-13 & J-14 Clearing Media Jam J-22 Printer Errors E-XX Error CodesError Code Cause Treatment Thumping Noise in Standby Door Open Errors U-XXProblem Cause Solution Image Quality Problem SolvingThis page is intentionally blank User Modes User Mode 1 Test Print U1User Modes User Mode 2 Date and Time setting U2 Hour Minute Second User Mode 3 Low Power Saver Mode U3 User Modes User Mode 4 High Power Saver Mode U4 User Modes User Mode 5 Media Cut At Power on U5 User Mode 6 Detack Lamp Control Mode U6 User Mode 7 Attention Beeper Enable Mode U7 User Mode 8 Custom Setting Plain Paper U8 User Mode 9 Custom Setting Vellum/Tracing Paper U9 User Mode a Custom Setting Film UA User Mode b Image Enhancement Ub 701P39415 4/2003 USA