Xerox 721P manual Clearing Media Jam J-22

Page 52

PROBLEM SOLVING

Slit

Cutter

8.Trim the lead edge of the roll square to remove any torn or wrinkled media by using the “Slit” if necessary.

9.Insert the lead edge of the media between the upper and lower feed rollers and feed an inch of media between the feed rollers.

10.Roll 3 only: Rotate the lower feed roller by hand until the lead edge is visible in the center of the viewing hole.

11.Press the [Online] Key to take the printer Offline (LED Off).

12.Push in the drawer until it is closed and latched.

13.If the leading edge is not sufficiently square, perform the automatic Initial Cut by pressing the [Select] key to select the appropriate drawer, and then pressing [Cut] key. Approximately 9.5” (240mm) media will be cut and fed from the printer.

14.Press the [Online] Key to return the printer Online (LED On).

Clearing Media Jam (J-22)

MF	Exit
MF
D1	PF
D2	PF
D2	Copy Density	Menu	Enter	Online
D3	D4

1. Remove the jammed media from the Stacker.

44	XEROX WIDE FORMAT 721P PRINTER OPERATOR MANUAL

Image 52

Contents Xerox Wide Format 721P Printer Operator Manual Page Table of contents User Modes Safety Notes Introduction EMC Notices Australia/New ZealandEuropean Union CanadaJapan USAIntroduction IntroductionOrganization And Content Of This Manual Terminology Used In This ManualConventions Used In This Manual BoldThis page is intentionally blank Specification Product SpecificationsMedia Specifications Room Space Requirements Serial Number LocationRoom Space Requirements Room Air Change Requirements For Ozone DissipationThis page is intentionally blank Printer Overview Printer OrientationMain Components Pins Not Used PinsService use only Rear Side ViewPrinter Overview Ready Indicator Operator Panel & Status DisplayMedia and Toner Status Panel Use IndicatorsRoll Size Displays Displays the size of the roll media Online/Offline Job Cancel Media Adding Media RollsLoading The Roll Media Roll 1, 2 Roll 3 only Loading The Roll Media Roll Belt Loading The Roll Media When Printing Dehumidifier Using Manual Bypass Feed When The Toner Cartridge Needs Replacement CareReplacing The Toner Cartridge Sealed opening Cleaning The Charge Scorotron Wire Wire-CleanCleaning The LED Print Head Exp-CleanCleaning The Printer Surface Ordering supplies Supply order procedureSupply order list This page is intentionally blank Problem Solving Media JamsClearing Media Jam J-01 & J-02 Problem Solving Clearing Media Jam J-03 Problem Solving Clearing Media Jam J-04 Green Knob Clearing Media Jam J-05 Clearing Media Jam J-11 & J-12 Slit Clearing Media Jam J-13 & J-14 Clearing Media Jam J-22 Printer Errors E-XX Error CodesError Code Cause Treatment Door Open Errors U-XX Thumping Noise in StandbyImage Quality Problem Solving Problem Cause SolutionThis page is intentionally blank User Mode 1 Test Print U1 User ModesUser Modes User Mode 2 Date and Time setting U2 Hour Minute Second User Mode 3 Low Power Saver Mode U3 User Modes User Mode 4 High Power Saver Mode U4 User Modes User Mode 5 Media Cut At Power on U5 User Mode 6 Detack Lamp Control Mode U6 User Mode 7 Attention Beeper Enable Mode U7 User Mode 8 Custom Setting Plain Paper U8 User Mode 9 Custom Setting Vellum/Tracing Paper U9 User Mode a Custom Setting Film UA User Mode b Image Enhancement Ub USA 701P39415 4/2003