Denon DCM-5001 manual Stand-Aloneplayback, Connecting the Analog Output Jacks, Other Connections

6 STAND-ALONE PLAYBACK

CONNECTION PRECAUTIONS

•Before proceeding with connections or disconnections of cable and power cords, be sure to turn all system components off.

•Ensure that all cables are connected properly to the L (left) and R (right) jacks.

•Insert plugs fully into the terminals.

•Connect the output jacks to the amplifier CD, AUX or TAPE PLAY input jacks.

Connecting the Analog Output Jacks

Connect one end of the connection cord supplied with the CD player to the output terminals, left (L) and right (R) of the CD player, and the other end to the CD, AUX, or TAPE PLAY input terminals, left (L) and right (R), of the amplifier.

DCM-5001

		1	DAISY CHAIN IN
		2	DIGITAL COAX IN	ATTENTION
		1	DAISY CHAIN OUT	ATTENTION
		2	DIGITAL COAX OUT
ANALOG OUT
		1
		2	REMOTE CONTROL IN
R	L
			1
DAISY CHAIN			2
	CONTROL
		1	0
MODE SWITCH
	EXTERNAL
	CONTROL		¢ RS232C

£ RS422A

Power Supply outlet

ZONE 1 Amplifier

ENGLISH

Connecting the Digital Output Jack (COAXIAL)

Use a 75 Ω /ohms coaxial pin cord to connect the digital output jack (DIGITAL COAX OUT) of the DCM-5001 to the digital input jack (COAXIAL) on a digital processor or D/A unit.

DCM-5001

Power Supply outlet

ZONE 1 Digital processor or D/A converter unit (Amplifier)

ZONE 2 Digital processor or D/A converter unit (Amplifier)

ZONE 2 Amplifier

NOTE:

When the single zone mode is selected, no digital data is output from the ZONE 2 side.

Other Connections

The DCM-5001 is provided with computer and remote control interface ports, for compatibility with external remote control solutions offered by third party vendors. Contact your dealer or installation consultant for advice if you are considering the purchase of an external control system.

9