Tripp Lite MT-SE-37/02 owner manual Snmp Solo

Page 1

SNMP Solo™

Owner’s Manual

for:

SNMP Solo™

by:

MT-SE-37/02	Copyright © 1999
12-DEC-99	93-1469 (9909097) 12/99

Image 1

Contents Snmp Solo Limited Warranty FCC Compliance Governing LawConventions Used In This Guide TrademarksTable of Contents Appendix Introduction Snmp Solo FeaturesExample Network With Snmp Solo Snmp Solo Package Snmp Solo Package ContentsStatus LEDs Power Supply Configuration CableTwo 3.5 Diskettes UPS Interface Cable System Requirements System Requirements Initial Installation Initial Installation Hardware adapter prior to configuring the device ConfigurationIP address Set IP And Gateway Addresses And MIB System GroupTripp Lite Configuration Access Controls Set Access ControlsSet Trap Receivers Trap Receivers Additional Setup Screen Additional Setup ScreenDisplay Settings To Save and Exit Reset Configuration to DefaultTelnet options TelNet OptionsExit Without Saving Upload FirmwareVerify the Snmp Solo Operation Final InstallationEstablish Network Communications General Network Management Stations Configuring the NMSPoll the Device OIDs From the Test Connectivity box Add Snmp Solo Object to the Management Map SunConnect SunNet ManagerPoll the Device OIDs Reference AppendixCommunities IP AddressesClass Value of First Network ID Host ID Number Subnetting and Subnet MasksRouting and Filtering GatewaysAgent GlossaryOID Plugged into their respective ports TroubleshootingComputer System Placing a Technical Support Call773 Technical SupportReference Worksheet