Tripp Lite MT-SE-37/02 owner manual From the Test Connectivity box

Page 33

Tripp Lite

Add SNMP Solo Object to the Management Map

The NMS will discover the NetMon and add it to the Management map during its discovery pass.

Poll the Device OIDs

1.From the main menu, select Tools then the SNMP MIB Browser.

2.From the SNMP MIB Browser box, select the IP protocol and then enter the IP Address.

a)select the profile to read.

b)select OK.

Set the Device OIDs

1.From the main menu, select Tools then SNMP MIB Browser.

2.From the SNMP MIB Browser box, select Add.

3.From the SNMP Profile Editor box,

a)assign the profile a name, a community, and a poll interval.

b)select the OID groups from the Group Choice then select Add to transfer them to the Group Selection(s).

c)Save the profile.

Ping the SNMP Solo

1.From the main menu, first select Fault, second Test Connectivity, and third Once.

2.From the Test Connectivity box,

a)type in the IP address.

b)select Test.

Configuring the NMS

27

Image 33
Contents Snmp Solo Limited Warranty FCC Compliance Governing LawConventions Used In This Guide TrademarksTable of Contents Appendix Introduction Snmp Solo FeaturesExample Network With Snmp Solo Snmp Solo Package Snmp Solo Package ContentsStatus LEDs Configuration Cable Power SupplyTwo 3.5 Diskettes UPS Interface Cable System Requirements System Requirements Initial Installation Initial Installation Hardware adapter prior to configuring the device ConfigurationIP address Set IP And Gateway Addresses And MIB System GroupTripp Lite Configuration Access Controls Set Access ControlsSet Trap Receivers Trap Receivers Additional Setup Screen Additional Setup ScreenDisplay Settings To Save and Exit Reset Configuration to DefaultTelnet options TelNet OptionsExit Without Saving Upload FirmwareVerify the Snmp Solo Operation Final InstallationEstablish Network Communications General Network Management Stations Configuring the NMSPoll the Device OIDs From the Test Connectivity box Add Snmp Solo Object to the Management Map SunConnect SunNet ManagerPoll the Device OIDs Reference AppendixCommunities IP AddressesClass Value of First Network ID Host ID Number Subnetting and Subnet MasksRouting and Filtering GatewaysAgent GlossaryOID Plugged into their respective ports TroubleshootingComputer System Placing a Technical Support Call773 Technical SupportReference Worksheet