Tripp Lite MT-SE-37/02 owner manual Reset Configuration to Default, To Save and Exit

Page 26

SNMP Solo

Location (location of your UPS and SNMP Solo)

List of the current communities with their access control code

List of the current trap receivers with their severity level codes

Reset Configuration to Default

If you press <6>, the program resets all fields to default. To display the results, press <5> for Display Settings. Most fields have no values.

Figure 11 Reset Values To Default

To Save and Exit

If you are satisfied with your configurations, save them and exit. To save, press <7>. The screen displays the following message:

Figure 12 Save and Exit Messages For Configuration

20Configuration

Image 26
Contents Snmp Solo Limited Warranty Governing Law FCC ComplianceTrademarks Conventions Used In This GuideTable of Contents Appendix Snmp Solo Features IntroductionExample Network With Snmp Solo Snmp Solo Package Contents Snmp Solo PackageStatus LEDs Two 3.5 Diskettes Configuration CablePower Supply UPS Interface Cable System Requirements System Requirements Initial Installation Initial Installation Configuration Hardware adapter prior to configuring the deviceSet IP And Gateway Addresses And MIB System Group IP addressTripp Lite Configuration Set Access Controls Access ControlsSet Trap Receivers Trap Receivers Additional Setup Screen Additional Setup ScreenDisplay Settings Reset Configuration to Default To Save and ExitTelNet Options Telnet optionsUpload Firmware Exit Without SavingFinal Installation Verify the Snmp Solo OperationEstablish Network Communications Configuring the NMS General Network Management StationsPoll the Device OIDs From the Test Connectivity box SunConnect SunNet Manager Add Snmp Solo Object to the Management MapPoll the Device OIDs Communities AppendixReference IP AddressesSubnetting and Subnet Masks Class Value of First Network ID Host ID NumberGateways Routing and FilteringGlossary AgentOID Troubleshooting Plugged into their respective portsPlacing a Technical Support Call Computer SystemTechnical Support 773Reference Worksheet