Tripp Lite MT-SE-37/02 owner manual Tripp Lite

Page 19

Tripp Lite

To assign the IP address of SNMP Solo, the gateway, and the network, type at the prompt:

1, <space>, the IP address of the SNMP Solo, <space>, MASK_BIT_COUNT, <space>, the IP address of the gateway.

The MASK_BIT_COUNT is used to indicate a mask for your gateway. The meaning of the numbers used in the MASK_BIT_COUNT will change based on the class of network you have. A Class A network has 24 options, a class B network has 16 options and a Class C has 8 options. The SNMP Solo automatically discovers the type of network in use from the first three digits of the IP address. The MASK_BIT_COUNT and the corresponding mask for each type of network is shown below.

Class A Network

0

255.000.000.000

12

255.255.240.000

 

 

 

 

1

255.128.000.000

13

255.255.248.000

 

 

 

 

2

255.192.000.000

14

255.255.252.000

 

 

 

 

3

255.224.000.000

15

255.255.254.000

 

 

 

 

4

255.240.000.000

16

255.255.255.000

 

 

 

 

5

255.248.000.000

17

255.255.255.128

 

 

 

 

6

255.252.000.000

18

255.255.255.192

 

 

 

 

7

255.254.000.000

19

255.255.255.224

 

 

 

 

8

255.255.000.000

20

255.255.255.240

 

 

 

 

9

255.255.128.000

21

255.255.255.248

 

 

 

 

10

255.255.192.000

22

255.255.255.252

 

 

 

 

11

255.255.224.000

23

255.255.255.254

 

 

 

 

Configuration13

Image 19
Contents Snmp Solo Limited Warranty FCC Compliance Governing LawConventions Used In This Guide TrademarksTable of Contents Appendix Introduction Snmp Solo FeaturesExample Network With Snmp Solo Snmp Solo Package Snmp Solo Package ContentsStatus LEDs Power Supply Configuration CableTwo 3.5 Diskettes UPS Interface Cable System Requirements System Requirements Initial Installation Initial Installation Hardware adapter prior to configuring the device ConfigurationIP address Set IP And Gateway Addresses And MIB System GroupTripp Lite Configuration Access Controls Set Access ControlsSet Trap Receivers Trap Receivers Additional Setup Screen Additional Setup ScreenDisplay Settings To Save and Exit Reset Configuration to DefaultTelnet options TelNet OptionsExit Without Saving Upload FirmwareVerify the Snmp Solo Operation Final InstallationEstablish Network Communications General Network Management Stations Configuring the NMSPoll the Device OIDs From the Test Connectivity box Add Snmp Solo Object to the Management Map SunConnect SunNet ManagerPoll the Device OIDs IP Addresses AppendixReference CommunitiesClass Value of First Network ID Host ID Number Subnetting and Subnet MasksRouting and Filtering GatewaysAgent GlossaryOID Plugged into their respective ports TroubleshootingComputer System Placing a Technical Support Call773 Technical SupportReference Worksheet