Tripp Lite MT-SE-37/02 owner manual UPS Interface Cable

Page 12

SNMP Solo

UPS Interface Cable

The manufacture-specific interface cable connects the UPS to the SNMP Solo unit. The table below defines the basic UPS device port configuration:

1	Low Battery	6	Not connected
2	Not Connected	7	Set to Voltage High (+12V)
3	Set to Voltage Low (-12 V)	8	Power Fail
4	Inverter Shutoff	9	Not connected

5Ground

6SNMP Solo Package

Image 12

Contents Snmp Solo Limited Warranty Governing Law FCC ComplianceTrademarks Conventions Used In This GuideTable of Contents Appendix Snmp Solo Features IntroductionExample Network With Snmp Solo Snmp Solo Package Contents Snmp Solo PackageStatus LEDs Configuration Cable Power SupplyTwo 3.5 Diskettes UPS Interface Cable System Requirements System Requirements Initial Installation Initial Installation Configuration Hardware adapter prior to configuring the deviceSet IP And Gateway Addresses And MIB System Group IP addressTripp Lite Configuration Set Access Controls Access ControlsSet Trap Receivers Trap Receivers Additional Setup Screen Additional Setup ScreenDisplay Settings Reset Configuration to Default To Save and ExitTelNet Options Telnet optionsUpload Firmware Exit Without SavingFinal Installation Verify the Snmp Solo OperationEstablish Network Communications Configuring the NMS General Network Management StationsPoll the Device OIDs From the Test Connectivity box SunConnect SunNet Manager Add Snmp Solo Object to the Management MapPoll the Device OIDs Appendix ReferenceCommunities IP AddressesSubnetting and Subnet Masks Class Value of First Network ID Host ID NumberGateways Routing and FilteringGlossary AgentOID Troubleshooting Plugged into their respective portsPlacing a Technical Support Call Computer SystemTechnical Support 773Reference Worksheet