SNMP Solo
b)A Windows’s communication screen with the typical SNMP Solo setting:
Figure 4 Communication Screen (Windows)
5.Press OK if you have the Windows Communications screen or accept your communication settings in the terminal emulation package. The terminal is now configured to communicate with the SNMP Solo adapter.
6.Connect the power supply with the 9VDC connector to the SNMP Solo adapter’s power input. Connect the other end of the power supply with a standard plug into the UPS. Approximately five seconds after you supply power, the adapter displays the introductory screen on your terminal. Press <enter> to get to the main menu.
7.You are now ready to configure the SNMP Solo adapter. Refer to the Configuration section for a detailed discussion.